Durango DEX210 Thread
#4156
Tech Elite
iTrader: (44)
ON another note I raced my second 210 on saturday. On my first pack I ran into a marshall walking down the front straight. My chassis was severly tweaked and I had to get medieval on it with channel locks and a vise. The good news is not one of the ballcups popped off from normal abuse. I did pop one of the steering links after hitting a wall jumping a 24 foot double.
#4158
Tech Elite
iTrader: (7)
I went with RPM ends and used ball studs from my Associated TC5 black short outter and silver long inner for the rear.
I herd to wait for the new rear camber link mount to come out because they are breaking the current ones.
I would like to go with the aluminum one if I can find something the weight may help some.
I herd to wait for the new rear camber link mount to come out because they are breaking the current ones.
I would like to go with the aluminum one if I can find something the weight may help some.
Last edited by twelvegauge; 02-05-2012 at 01:55 PM.
#4160
Tech Rookie
#4161
Tech Regular
#4163
#4165
2pc design, 3mm thick garolite with delrin base.
#4167
#4168
i did get a small shipment of bugleboy bodies in! RCink is painting mine up right now here is the body, still has to finish the wing and undertray.
#4169
These are the ones I use. I just have them in white.
http://www.jconcepts.net/store/index...products_id=23
#4170
Tech Master
iTrader: (26)
Finally got around to painting my Finnisher.
I ordered the brace from you last week. You going to wait and send me the v2?
I think this was the one. Pretty sure it was in a TLR package though.
http://www.amainhobbies.com/product_...st-Bearing-Set
I ordered the brace from you last week. You going to wait and send me the v2?
I think this was the one. Pretty sure it was in a TLR package though.
http://www.amainhobbies.com/product_...st-Bearing-Set