R/C Tech Forums
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

R/C Tech Forums (https://www.rctech.net/forum/)
-   Australian Racing (https://www.rctech.net/forum/australian-racing-29/)
-   -   Hex drivers (https://www.rctech.net/forum/australian-racing/910020-hex-drivers.html)

Sully 02-04-2016 02:30 AM
Originally Posted by iJRacing (Post 14376162)
The MIP units handles look like they are heavy and leftover from the 1980's.
They are slightly heavier than EDS drivers but its not noticeable, they are also shorter, the 2mm MIP driver is about 1 inch shorter than the 2mm EDS, Only comparing MIP to EDS because they are the 2 i have.

The ultimate set up would be MIP power tool bits with a 1/4 bit driver handle, just don't get the Hudy one because they dont fit very well.


All times are GMT -7. It is currently 08:55 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.