Problem with 5925 digital servo
 

I have a 5925 digital servo that I use for steering on my 1/10 car, an Asso B4. I own this servo from about an year, and it has always worked fine. Suddenly it started to pause when returning to center. I can turn one way, but when I go to turn it to center or the opposite direction - it sort of pauses then turns the intended direction. If I turn slowly in both diretions it works, but if I turn faster, it starts to pause. One or more seconds :flaming: pause! I have read another one has had the same problem with the same servo in the past. I own an Hitec 4 Flash Pro tx/rx with LRP 7.1 ESC and a Sanwa (Airtronics) M8 tx/rx with Mamba Maxx ESC. Same problem. I also checked the servo with the Hitec HFP-10 Digital Servo Programmer and it works FINE. :o unbelievable :mad:
Any help :confused: :confused: ?? It needs TLC? I presently live in Italy, can I find a service here?
Thanks in advance
Alex

Has the servo always been used with this equipment or is this a new setup and a new problem? Whats teh BEC amperage rating on that LRP ESC? Is this problem occuring with the Flash or the M8 or both radios?


Your service center in Italy is:
ITALY
SAFALERO
MR. ROMUALDO
GAROFALI VIA DELL’ARTIGIANO 29,40065
PIANORO, BOLOGNA, ITALY
39-51-6516132
39-51-6516197
[email protected]

Hi Brendan,
thank you for your fast reply. Yes, the servo has always been used with this setup and it's a new problem that occurs with both radios. The ESC is a LRP 7.1 digital, you can find the spec here
It's a good ESC as Mamba. I don't understand why the servo works fine with the Hitec HFP-10 Digital Servo Programmer. Any suggestion?
Alex

Originally it sounded like maybe a motor issue but if it works properly when connected to teh programmer then it sounds like a voltage/amperage issue (not getting enough). If the servo acts up only when ther eis a load applied to it then I would say you are exceding the amperage limit of the ESC's BEC current.

HS-5965MG
 

I have the same problem with my HS-5965MG . I'm using Novak GTB and I can not get it to center.(no load) I changed radios and everthing. My 645 worked fine. Do I need to send it back?????

Mike G, I would send it to make sure all is well.