Hitec HS-225MG
04-24-2003 | 10:08 PM
#1
Thread Starter
Tech Initiate
Joined: Feb 2003
Posts: 44
From: Auckland, New Zealand
Hitec HS-225MG
I just bought a Hitec HS-225MG Mini Precision servo. I run a Tamiya TB-01 and used to have a Futaba S3003 steering servo.
I noticed ure servo was much smaller, so I asked the guy at this hobby store, and he said it would fit into a TB-01 fine.
I take out the Futaba servo, and I do whatever the car manual says I should with any servo.
Then I realize that the length is too short, and can't reach one of the holes in the chassis. What should I do?
I noticed ure servo was much smaller, so I asked the guy at this hobby store, and he said it would fit into a TB-01 fine.
I take out the Futaba servo, and I do whatever the car manual says I should with any servo.
Then I realize that the length is too short, and can't reach one of the holes in the chassis. What should I do?
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
