R/C Tech Forums - using channel for flaps

R/C Tech Forums (https://www.rctech.net/forum/)

- Ask Hitec (https://www.rctech.net/forum/ask-hitec-40/)

- - using channel for flaps (https://www.rctech.net/forum/ask-hitec/169771-using-channel-flaps.html)

ronshenk

06-25-2007 07:51 PM

using channel for flaps

I have a HiTec Eclipse 7. I want to use channel 7 for flaps. I would like to
start with the switch in the rearward position and the flaps be up. When the
switch is moved to the forward position, the flaps should go down.
I have both flaps operating on one servo.

Is this possible?

ron shenk

BRENDAN LUGO

06-27-2007 08:32 AM

Are you trying to set this up in the ACRO mode?

If you are then channel 7 is controlled by the VR2 knob. You can use PMIX 1 or 2 to mix channel 7 to itself and then the channel 7 switch will control this channel along with the VR2 knob.

All times are GMT -7. It is currently 05:42 PM.