R40Victim

iTrader: (1)

If it'll fit in the same space as a typical 6 cell stick pack. The battery goes up inside the starter.

Davenport

Anyone know who might have this in stock. Amain hobbies is the only online store that I could find it on and they are out of stock.

Muchmore Li-Ion and Li-Poly 6.5V, 7A Servo Voltage Regulator
[MGL-MRG-7A]

*Topher*

iTrader: (2)

I haven't ran the Losi wing yet so I can't comment.

I have been running the Himoto wing and versus the proline wing it last far longer. Performance wise I am not good enough to tell much difference.

lockmouth

iTrader: (33)

http://www.stormerhobbies.com/cgi-bi...e=&man=&page=1

Stormer sells them, but they are out of stock on the 7amp regulator. They have the 5 amp and 3 amp in stock.

G Mills

iTrader: (7)

With out the time to go through the whole thread, could someone outline the necessary mods that need to be done? Thanks.

maxx90

iTrader: (104)

IS ANY ONE BALANCING THEIR 1/8 TIRES AND WHEELS. IF SO WHAT DO YOU USE. THNX

rezenclowd3

iTrader: (17)

Only one "modification" needed. Put a 10th scale shock o-ring under the battery box and instead of using the supplied screw, use a 1/2 inch long one, and screw it in just till it is flush with the inside of the battery box. This reduces vibrations to the throttle servo. Other than that, nothing is needed as far as after-market parts.

G Mills

iTrader: (7)

Because the battery box holes don't line up perfectly, the screw gets hung up on the last thread and hangs down. Did I just get a bad chassis or is this normal. It's really annoying for a perfectionist......

DrJekyll

Hiya, i think this has been asked before somewhere in the this thread, but what is the correct rating of the shock springs?? Red, Green, Black and silver. Rating from hardest to softest?

Cheers, Leigh

Matt Howard

iTrader: (6)

magnetic prop balancer and some modeling clay for weight

T Green

i use this and shoe goo for weight, if you need a lot of weight use a old screw in the shoe goo.


http://www.bluegrasshobbies.com/bg/c...roducts_id=471

maxx90

iTrader: (104)

HOW DO YOU ADAPT TO THE PROP BALANCER?

Walt

iTrader: (2)

I use a spare axle and wheel nut (actually, an old one from a previous buggy).

*Topher*

iTrader: (2)

Has anyone noticed that the front end of the car gets a sloppy after just a little use?

GTB_USER_Erik

Define "gets a sloppy after a little use"?