Serpent S411
#466
SPEC-R BLADES
#470
S411 BLADES
Cheers
Ren
#472
#473
Tech Regular
iTrader: (3)
i have a tc6 and my brother used some blades for his 411 and he went from changing a set a run to runnimg whole day and looking like the sand paper mark was still there with a 4.5 in the car. I alw habe 4.5 and habe done 3 race meets without killing any yet. Also very cheap
#474
Tech Regular
Hello Guys:
Probably this has bees asked before, but I can't find it. Can some one tell me what brand or spurs I can use?? I foudn that all Robinson or Hot bodies doesn't fit 3 hole system.
Probably this has bees asked before, but I can't find it. Can some one tell me what brand or spurs I can use?? I foudn that all Robinson or Hot bodies doesn't fit 3 hole system.
#475
Tech Lord
iTrader: (86)
I put on 2mm chassis today it was okay...I was getting too much rear grip after two minute marks...it statred to drive like a dump truck...
I even changed the rear roll center to high and stiffer spings in the rear (yellow to orange) front red spring
Some how the car drive perfect for stock,but for mod it is lacking forward bite later in the middle of the run...could be the chassis is too thin?