Durango DEX210 Thread
#2732
Tech Lord
iTrader: (52)
Yep.. the little guy that the slipper spring and it's washer sit up against. My gearbox comes apart every 3 or 4 race days, and it looked fine the last time I had it apart... I don't like sudden bearing failure! I will report if I have another go out... maybe I just had a bad bearing.
#2735
Tech Elite
iTrader: (149)
Gearing
Hey guys, need a little help on gearing. I am currently running the MM3 setup on the car with and lrp 8.5t and viper ESC. Track is small and very technical. Last week, my esc wouldnt turn on after running a full battery through the car. I sent the ESC in for repair and was told that my current setup is to aggressive. Im running 81t spur with 24t pinion. After running the car for 10 min, the ESC and motor were not hot at all. I was able to touch both without any issues. My throttle epa is also turned down to 80%. What gearing would you recommend to start off with?
#2736
Tech Adept
Great work! I know a lot of people here in the UK could do with one of these as they have broken so many! Just a thought but It would be nice to see this part be able to take the plastic pill adjustable inserts that are for the V3 410 rear brace. Then it would be fully adjustable.
#2738
Tech Adept
I am running a 83T/24T with a SP V3 7.5 with the stock settings on the latest firmware of a HW 120A V2.1 ESC and it is really great and does not get hot at all.
#2739
Upgrade, don't replace. I have found the Durango bearings are crap. I have had two fail, and my buddy one.
#2740
Hey guys, need a little help on gearing. I am currently running the MM3 setup on the car with and lrp 8.5t and viper ESC. Track is small and very technical. Last week, my esc wouldnt turn on after running a full battery through the car. I sent the ESC in for repair and was told that my current setup is to aggressive. Im running 81t spur with 24t pinion. After running the car for 10 min, the ESC and motor were not hot at all. I was able to touch both without any issues. My throttle epa is also turned down to 80%. What gearing would you recommend to start off with?
#2742
Tech Champion
iTrader: (14)
Yep.. the little guy that the slipper spring and it's washer sit up against. My gearbox comes apart every 3 or 4 race days, and it looked fine the last time I had it apart... I don't like sudden bearing failure! I will report if I have another go out... maybe I just had a bad bearing.