Speedmerchant Roadkill 10 235mm Pro10 Pancar
#151
Hi Guys,
Hope everyone had a nice weekend.
The rest of the RoadKill 10's are going out this week.
Our friend Arnaud from PetitRC did a set-up sheet for the RoadKill.
http://www.petitrc.com/reglages/spee...chantRK10.html
Have a great day.-Bruce
Hope everyone had a nice weekend.
The rest of the RoadKill 10's are going out this week.
Our friend Arnaud from PetitRC did a set-up sheet for the RoadKill.
http://www.petitrc.com/reglages/spee...chantRK10.html
Have a great day.-Bruce
#153
Pics!
#157
Mounted servo, servo saver, needs 4-40 or other inner ball stud. I used 1/4" flathead screws over the 1/8" screws included.
Mounted brick battery stop forward. Battery will still need tape to secure it.
4-40 cap head screws needed for rear axle. I have CRC/Associated aluminum in at the moment, but have stainless ready to go in.
Need to build the shock, lube and mount the side dampers, mount the front bumper and fit a foam protector, slip in the rear axle and mount electronics and fit a body.
The RC Screwz Gen X 10 kit is coming in handy!
Mounted brick battery stop forward. Battery will still need tape to secure it.
4-40 cap head screws needed for rear axle. I have CRC/Associated aluminum in at the moment, but have stainless ready to go in.
Need to build the shock, lube and mount the side dampers, mount the front bumper and fit a foam protector, slip in the rear axle and mount electronics and fit a body.
The RC Screwz Gen X 10 kit is coming in handy!
#159
Need to raid my CRC stuff for bearings and shims for front and rear. Can't really put the rear in without shims. Shock is built and installed with 40 wt. Losi oil to start. Battery is taped in, but still loose side to side. Damper tubes next with 20k CRC lube to start. I need 8mm motor screws too!
#162
So the kit came with no front or rear bearings?
#164
You will need shims, 1/4 and 1/8.
Front bearings 1/8 inch ID FLANGED: 4.
Rear bearings 1/4 inch ID: 2 flanged, 3 regular.
Turnbuckles, 2 1/4 inch Lunsford work great.
Lunsford or Associated regular or long 4-40 ballcups.
Associated 1/4 inch ball studs 4-40 thread: 2.
A spur gear.
Diff balls and rings come with the axle kit from IRS.
Shock oil.
Damper tube grease.
Tires.
Front bearings 1/8 inch ID FLANGED: 4.
Rear bearings 1/4 inch ID: 2 flanged, 3 regular.
Turnbuckles, 2 1/4 inch Lunsford work great.
Lunsford or Associated regular or long 4-40 ballcups.
Associated 1/4 inch ball studs 4-40 thread: 2.
A spur gear.
Diff balls and rings come with the axle kit from IRS.
Shock oil.
Damper tube grease.
Tires.