Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
#4861
Tech Addict
What's the difference between the 521-01 arms, WC arms and the NCG arms (yes I know the drop down..)
I run a FS2 SP and DB1, so have plenty of rear arms.
I run a FS2 SP and DB1, so have plenty of rear arms.
#4863
It is common practice to run 521 arms with the narrow holders, and 521-01 arms with wide holders? I'm assuming the one hole 521-01 is needed to offset the wider holders, so I can run the same shock ball ends, whenever one runs the outer hole on the 521 with narrow holders?
Any situations where I need 521 with wide, or 521-01 with narrow? Thanks,
Any situations where I need 521 with wide, or 521-01 with narrow? Thanks,
#4864
I need some blue .5 Hubs.. Pm me if you have some I can buy
#4865
Finished up the build of my RB6. Superb. The first 1/10 K car I have built after running AE for as long as I can remember. The shocks are even better than my Tki3. Lunsford turnbuckles and Ti screws throughout. just waiting on the carbon battery braces to finish it off
First run will be when I get to the USA in 10 days
First run will be when I get to the USA in 10 days
#4867
Tech Regular
iTrader: (39)
Matt has exactly what you need for a GREAT price!
http://www.rctech.net/forum/r-c-item...5-rt5-scr.html
http://www.rctech.net/forum/r-c-item...5-rt5-scr.html
#4868
Matt has exactly what you need for a GREAT price!
http://www.rctech.net/forum/r-c-item...5-rt5-scr.html
http://www.rctech.net/forum/r-c-item...5-rt5-scr.html
#4869
Ti screws
Ben73 - very clean looking build, nice! Curious what titanium screw kit you used and where to purchase in the states?
#4870
http://www.titaniumscrews.net
I got on to them last year because I wanted to kit my Tki3 all Ti - the price is really good. And the quality is amazing. The only issue is its usually min 50 pieces per size. But when you are doing 4 1/8th cars per year to add a couple of 1/10th makes it cost effective.
#4871
It is common practice to run 521 arms with the narrow holders, and 521-01 arms with wide holders? I'm assuming the one hole 521-01 is needed to offset the wider holders, so I can run the same shock ball ends, whenever one runs the outer hole on the 521 with narrow holders?
Any situations where I need 521 with wide, or 521-01 with narrow? Thanks,
Any situations where I need 521 with wide, or 521-01 with narrow? Thanks,