glenng

iTrader: (1)

I dont think they make m4 scrubs for up front 2wd. Havent seen em before and have looked. They have suburbs m4 for upfront

thefan

iTrader: (3)

Yeah thanks i thought 0 antisquat would be better but all the setup sheets i looked at had 3 , im not trying to keep one setup for both carpet and dirt just dont want to go from mm to rm

flame56mx

iTrader: (520)

Gotcha, and I agree with you, going from rear to mid wouldn't be much fun.

cripplethreat

iTrader: (6)

Do you guys think they will make the Phantom body for the 210? I love the look!

Lead-Lobber

iTrader: (1)

Hey guys, horrible day at the track yesterday. Never finished a full run...
Here is what happened. I caught a pipe and popped the drag link from the servo horn to the steering bell crank. OOOPS, My bad.
Well, it was never the same after that and kept popping about every other lap. Damn...

So, now what is the fix for it? Order the stock parts, or replace aftermarket?
Part numbers for aftermarket?

Once again, you guys rock with the wealth of knowledge.

Cheers. Jeff

fredswain

iTrader: (1)

I personally run Lunsford Punisher turnbuckles and ball cups and ball studs from the 22. I even run this setup on my vintage cars. No problems ever.

Walkman

iTrader: (29)

Lunsford, they are pricey buy they are worth it!

rcjunky1

iTrader: (10)

He's poping the link to the rack, no a camber link or toe link. You want the dimecx ball cups, that should solve everything.

Lead-Lobber

iTrader: (1)

thanks RCjunky1. That's the ticket.

Dino_D

If you use the stock ones, once you pop it, just replace it with a new one. Or like Junky said, get the new dimex

micholix

Did someone see, that TD have got the options for different chassis lgth on the new V2 setup sheets?

There is the option for standard, for +8 and +24 length!?

Do you think that there will coming a +24 chassis, or do you think, that is a mistake?

fredswain

iTrader: (1)

I use those ball cups and ball studs from the 22 as well.

P6

iTrader: (5)

Losi 22 cups and ball stud with Lunsford turnbuckles i havent popped one yet it did add a few grams being the ballstuds are 4.8mm and steel

Lead-Lobber

iTrader: (1)

Are there any worries with cutting down a ball cup to fit the length needed in that drag link to the rack? Its a short tiny thing...

And what lenght ball studs. Losi has varying lenghts, from 6mm to 10mm I believe. I don't have access to my build manual. Does it list the sizes in there?

fredswain

iTrader: (1)

The ball studs and cups that Losi uses on the steering rack are smaller than all of the others. They are the same size as the old smaller pieces such as those used by Associated or the previous Losi pieces. These are unique to that location.