Team ORCA USA Discussion Thread
#436
Team EAM
iTrader: (79)
Eric do you have, or can you get, replacement motor cans? I just need the end the motor mounts to. Managed to hit something with my TC and bent it slightly. I rotated the can 60 degrees or whatever it is and the motor mounts straight in the car now but would like to replace it if I can.
EA
#437
Tech Master
iTrader: (41)
Looking for FDR suggestions for 17.5TX.
This is the track layout which as you can see (see video) is tight and technical accompanied with a 82 foot long straight.
http://www.youtube.com/watch?v=gCFMSryT7k8
Now, in the video below I am using a TRION 17.5 (Japanese) with a 13.5 rotor.. crazy torque, but too much off throttle drag.. Now the speed control is using dynamic hybrid boost turbo (reventon pro 1.1)
The only problem is now my track has decided on doing away with motor timing and esc boost/turbo ect.
In summary we can only run blinky/fixed timing.
This is the track layout which as you can see (see video) is tight and technical accompanied with a 82 foot long straight.
http://www.youtube.com/watch?v=gCFMSryT7k8
Now, in the video below I am using a TRION 17.5 (Japanese) with a 13.5 rotor.. crazy torque, but too much off throttle drag.. Now the speed control is using dynamic hybrid boost turbo (reventon pro 1.1)
The only problem is now my track has decided on doing away with motor timing and esc boost/turbo ect.
In summary we can only run blinky/fixed timing.
#440
Thanks
EA,
Got my lipos today , Thanks
Got my lipos today , Thanks
#442
Tech Fanatic
iTrader: (27)
At practice yesterday, running a 17.5 TX, my motor fan disconnected itself from the chassis and tore off. I must've run for a long time without one (I drove for about 8 mins). After the run I found out he motor was at 180f on the outside, and about 200 temped on the inside, but I noticed NO motor fade at all. I started te run on a fresh battery doing about 11.7s/11.8s consistently and I finished the run with an 11.8 before I pulled off. This motor is incredible.
#443
Has anyone in the WCICS series tried to update the ORCA Q'Spark ESC's Firmware? after seeing that their is one available. Results did you get it to performe any better than the stock?
http://www.orcarc.com/en/download.asp
http://www.orcarc.com/en/download.asp
#444
ORCA infinite ultra ROAR approved?
Are the new ORCA infinite ultra batteries ROAR approved?
Thanks.
Thanks.
#445
#446
Tech Elite
iTrader: (29)
Has anyone in the WCICS series tried to update the ORCA Q'Spark ESC's Firmware? after seeing that their is one available. Results did you get it to performe any better than the stock?
http://www.orcarc.com/en/download.asp
http://www.orcarc.com/en/download.asp
I've been using mine for 3 years and haven't updated it. Still plenty fast.
#448
#450