VBC WILDFIRE D07
#301
Tech Fanatic
Sounds like there is a new car coming out to replace the VBC Ghost. I'm curious about when a dynamics edition D07 will be hitting the market.
#302
I had also heard from someone that a Nitro TC may be in the works.
#303
me too!
i guess the d07 dynamics will be available in summer.
and 3 or 4 months later we will see the d08... this strategy is the only thing i don't like at vbc
except of that i love them
i guess the d07 dynamics will be available in summer.
and 3 or 4 months later we will see the d08... this strategy is the only thing i don't like at vbc
except of that i love them
#306
Regional Moderator
iTrader: (1)
Would the D07 work with normal servos? Trying to save some money and reuse my standard size Futaba servos but not sure if this would severely limit the space for esc/receiver and/or throw the balance of the car. All the setup ive seen uses a low profile servo.
Last edited by disaster999; 03-11-2015 at 12:26 AM.
#308
Tech Elite
iTrader: (3)
binding steering???
Guys, my steering assembly moves freely, full lock, left and right, but binds up to almost no movement with the TJDs (Two-Piece Joint Drives) installed. I removed them and noticed, that, if you move the axle left and right to simulate steering, the inner axle moves in the opposite direction. I believe this is causing the binding when installed in the car. Has anyone else experienced this problem? Is there a fix???
#311
Guys, my steering assembly moves freely, full lock, left and right, but binds up to almost no movement with the TJDs (Two-Piece Joint Drives) installed. I removed them and noticed, that, if you move the axle left and right to simulate steering, the inner axle moves in the opposite direction. I believe this is causing the binding when installed in the car. Has anyone else experienced this problem? Is there a fix???
#313
just check if you turn if the tjd hit the chub, and if the chub at the straight side have a bevel, if not dremel one yourself, you can check with new one what i mean