Tamiya TB Evo 6
#903
Tech Apprentice
For those using a rear diff setup in the front, should I use rear (#53502) swing shafts - 42mm along with the front wheel axle, joint pipe etc?
Thanks!
Thanks!
#906
gee whiz, rc mushroom is selling the new black tb evo 6 for $150 less than what they sold the blue one for.
#909
Tech Master
iTrader: (14)
Only had mine about a month or so but loving it! Easy to drive and very rewarding when you're on it hard. Only 2 criticisms: it's a bit heavy, mine weighs in at 1440g even with lightweight electronics and the front sway bar set-up is rubbish (the sway bar end rubs on the dcj at full susp travel). I replaced this with a Serpent setup and it was fine. But overall its a great car and makes a great noise when at WOT
#910
I want to buy the new TB EVO 6 Black.
The spool gear was always worn in ancient EVO 6. There were always porridge, after a couple of runs.
Any news about that rubbish??
The spool gear was always worn in ancient EVO 6. There were always porridge, after a couple of runs.
Any news about that rubbish??
#911
Tech Master
iTrader: (40)
Join Date: Jul 2003
Location: El Pueblo de Nuestra Señora La Reina de Los Ángeles del Río de Porciúncula, California, Unites States of America
Posts: 1,185
Trader Rating: 40 (100%+)
None of my evo6 gears ever stripped on 17.5, not to this day and it's been through the hands of myself as a rookie and my brothers as a rookie into intermediate/sportsman. We've had the car since it came and out racing in every 2 weeks since.
#912
13.5 Turn there was always mash in front
#913
Try changing to Yokomo SD gears. Those are a tough nylon, longer and finer pitch. I have managed to adapt an EVO6 gear diff to take the crown and works fine. The front should be a lot easier (but you'll have to do the rear diff as well, as the ratio is different).
Last edited by niznai; 04-18-2015 at 12:44 AM.
#914
Tech Elite
iTrader: (5)
I have a NIB EVO 6 for sale. New lowered price. check it out
http://www.rctech.net/forum/r-c-item...l#post13947654
http://www.rctech.net/forum/r-c-item...l#post13947654