Serpent 966
#1426
Tech Elite
iTrader: (19)
That's good to hear. I have not seen the front's listed anywhere though, only the rear's.
Will need to swap out my front's as one has a little tweek in it and wobbles when spinning. I don't know how it happened as I have not crashed it, very odd. CSO finish looks good and I have noticed a lot of people running their pulleys, even the top drivers. Good price also.
Will need to swap out my front's as one has a little tweek in it and wobbles when spinning. I don't know how it happened as I have not crashed it, very odd. CSO finish looks good and I have noticed a lot of people running their pulleys, even the top drivers. Good price also.
#1427
No offense dude but Serpent is a dutch company. Yea parts are made in china but thats the case in like all the RC car manufacturers except XRAY.
#1428
Tech Regular
iTrader: (1)
CSO lightweight 2-speed shaft
Hi,
has anyone used the CSO lightweight 2-speed shaft?
I have 2 of them, and for both, there seems to be no thread inside the shaft to allow me to use a set-screw to hold the pin that sits in the 2-speed adaptor shaft.
can anyone shed some light?
sam
has anyone used the CSO lightweight 2-speed shaft?
I have 2 of them, and for both, there seems to be no thread inside the shaft to allow me to use a set-screw to hold the pin that sits in the 2-speed adaptor shaft.
can anyone shed some light?
sam
#1433
What gears are you guys running on the 966 at Homestead, pinion/spers
#1436
Tech Regular
#1438
Tech Adept
clutch configuration
hi,
Just wondering what will give a better punch out of corners..flyweight leading or trailing or between pins ? Or someone can give me a good setup for clutch for maximum punch out of corners.
thanks
Just wondering what will give a better punch out of corners..flyweight leading or trailing or between pins ? Or someone can give me a good setup for clutch for maximum punch out of corners.
thanks
#1440
Tech Initiate