Team Associated T5M Discussion
#1051
#1054
Hmm don't know what to think of the truck, it looked good, but it didn't.. Like almost inconsistent? Maybe I'll give the people who have the truck a few more weeks to figure it out.
Anyone else kinda experiencing similar thing?
Going to hold on to the RT6 for now!
Anyone else kinda experiencing similar thing?
Going to hold on to the RT6 for now!
#1055
Tech Champion
iTrader: (7)
Where in the world are you buying from ?????
I got my AKA Chainlinks for $16.99/pr ( with great foams included) and $5.99 for AE wheels from Tower. That is only $46 for all 4. If you use Barcodes, then they are $2 cheaper, but then add $18 for AKA foam so a total of $62. There are a lot of coupons as well to bring the cost down.
For my buggy, the chainlinks are $18.99/ pr mounted and pre-glued.
There is no need to waste so much money on tires.
I got my AKA Chainlinks for $16.99/pr ( with great foams included) and $5.99 for AE wheels from Tower. That is only $46 for all 4. If you use Barcodes, then they are $2 cheaper, but then add $18 for AKA foam so a total of $62. There are a lot of coupons as well to bring the cost down.
For my buggy, the chainlinks are $18.99/ pr mounted and pre-glued.
There is no need to waste so much money on tires.
#1057
Sensor Wire Routing
Concerned about battery damaging sensor wire when routing in slot at base of chassis. Had a problem with b5m using the same config and changed to running sensor wire on top of battery along with motor wires. Any tips on protecting sensor wire when routing it under a square pack battery?
#1058
Concerned about battery damaging sensor wire when routing in slot at base of chassis. Had a problem with b5m using the same config and changed to running sensor wire on top of battery along with motor wires. Any tips on protecting sensor wire when routing it under a square pack battery?
http://www3.towerhobbies.com/cgi-bin...?&I=LXCBFR&P=7
#1059
Tech Regular
I've just been using tape to hold the sensor wire down. And my t5m was hooked up!
#1062
Tech Master
iTrader: (77)
T4.2 Factory Team blue aluminum rear 12mm hex
Does anyone know if these will work with the T5M ?
Team Associated 12mm Aluminum Clamping Wheel Hex Set (Blue)
Team Associated 12mm Aluminum Clamping Wheel Hex Set (Blue)
#1063
Tech Champion
iTrader: (170)
Does anyone know if these will work with the T5M ?
Team Associated 12mm Aluminum Clamping Wheel Hex Set (Blue)
Team Associated 12mm Aluminum Clamping Wheel Hex Set (Blue)
#1064
No way...$94?
Dude...
I bought a set of "unobtanium" Proline MC Primes for my ST and paid full retail and only spend $50 for tires.
#1065
Stock setup looked really good, looks like the truck has a ton of grip.