I ran my EVOIII today, handled GREAT, and had a few BIG crashes...
I noticed this when I was changing a rear input gear...
The gears do not seem to mesh "flush" with eachother. To me it seems that the very outside of the teeth on the gears are what touch eachother, and where most striping occurs. (Kind of like the two gears are too flat, and the inner part of the teeth rarly touch) I noticed that on my TC3, the gears' teeth are in contact with each other over the entire mesh at all times.
Has anyone else noticed this?
(I am still looking through the pages of this thread, so if it has, disregarde this post
)