R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Roelof
Showing results 1 to 25 of 500
Search took 0.42 seconds.
Forum: Radio and Electronics
Today, 12:39 PM
Replies: 10
Views: 149
Posted By Roelof

Then you have to route the red wire of the servo...

Then you have to route the red wire of the servo to the red wire of the BEC/ESC.
Forum: Electric Off-Road
05-23-2024, 06:54 AM
Replies: 5
Views: 229
Posted By Roelof

So you have changed something and then one wheel...

So you have changed something and then one wheel does not spin right. It never came to your mind that the cause is basically with the change you have done?
Forum: Nitro Off-Road
05-22-2024, 11:29 PM
Replies: 28
Views: 930
Posted By Roelof

Yes, but it is not only the wall I am talking to...

Yes, but it is not only the wall I am talking to but all others who consider to take the advise from the wall.
Forum: Nitro Off-Road
05-22-2024, 09:35 AM
Replies: 28
Views: 930
Posted By Roelof

Yes, both will result in an easier sart but one...

Yes, both will result in an easier sart but one will make scratches and other tiny damages to the piston surface and the other not. On microscopic level the surface of a new piston looks like a screw...
Forum: Radio and Electronics
05-21-2024, 02:36 PM
Replies: 10
Views: 316
Posted By Roelof

Some searching can help.... Motolyser II...

Some searching can help....
Motolyser II firmware and bluetooth printer questions - R/C Tech Forums (rctech.net)...
Forum: Onroad Nitro Engine Zone
05-21-2024, 12:25 PM
Replies: 6
Views: 2,407
Posted By Roelof

To give you a reason to buy the new one with the...

To give you a reason to buy the new one with the 3 weights because the older with 2 weight is not fast anymore.

The weights are basically for balancing, maybe in the hands of a very good driver he...
Forum: Nitro Off-Road
05-21-2024, 09:09 AM
Replies: 15
Views: 931
Posted By Roelof

All his advises are short and missing essential...

All his advises are short and missing essential information. Only about the use of 14 to 18% oil he is always very clear.
Forum: Rookie Zone
05-21-2024, 07:48 AM
Replies: 7
Views: 270
Posted By Roelof

All you said? See a quote of your post in red.......

All you said? See a quote of your post in red.... I clearly see an advise to switch 2 wires. And then, do not connect the sensor wire? You are sure the ESC is auto sensing sensored/sensorless? And...
Forum: Nitro Off-Road
05-21-2024, 01:34 AM
Replies: 15
Views: 931
Posted By Roelof

I think he means that with less oil the...

I think he means that with less oil the lubrication also becomes critical when you tune the engine too lean, with a high percentage of oil a good lubrication remains when going too lean. But still...
Forum: Radio and Electronics
05-20-2024, 03:26 PM
Replies: 1
Views: 121
Posted By Roelof

Check the device manager if the hardware is...

Check the device manager if the hardware is actually installed.
Forum: Nitro Off-Road
05-20-2024, 01:41 AM
Replies: 15
Views: 931
Posted By Roelof

And it never comes to your mind that there are a...

And it never comes to your mind that there are a lot of differences between IR temperature meters? And do not forget that humidity and air pressure has also a huge influence on the engine...
Forum: Nitro Off-Road
05-20-2024, 01:30 AM
Replies: 28
Views: 930
Posted By Roelof

You do not have to buy break in fuel, Most RTR...

You do not have to buy break in fuel, Most RTR fuels have some extra oil and most people just add some drops castor oil, Eurol Racing-1 is what I use.

But that in red is what I explained before,...
Forum: Nitro Off-Road
05-19-2024, 09:29 AM
Replies: 28
Views: 930
Posted By Roelof

@jumjum01 Again, do not take any advise from...

@jumjum01
Again, do not take any advise from this MonsterT guy. Pre-heating is always good for the engine and break-in fuel is indeed not needed as long you keep the engine rich (then it gets more...
Forum: Nitro Off-Road
05-19-2024, 06:08 AM
Replies: 28
Views: 930
Posted By Roelof

Pre-heating always works, even in real racing...

Pre-heating always works, even in real racing engines are pre-heated by pumping hot fluid through the cooling system. Also about too much oil I explained you a lot that too much gives resistance and...
Forum: Radio and Electronics
05-19-2024, 01:48 AM
Replies: 8
Views: 346
Posted By Roelof

Beside that. Programming some parameters is just...

Beside that. Programming some parameters is just a minute work, why not wait until it is all build in and connected if you are not sure?
Forum: Nitro Off-Road
05-19-2024, 01:43 AM
Replies: 28
Views: 930
Posted By Roelof

Did you read the topicstart well? The...

Did you read the topicstart well?
The pistonpin was seized up, that looks more like a bad tolerance thing and not a lubrication.
Although I think it was more a stuck piston in the pinch zone.
Forum: Rookie Zone
05-18-2024, 08:43 AM
Replies: 7
Views: 270
Posted By Roelof

Which 2 wires? Of the power? You know there are...

Which 2 wires? Of the power? You know there are people that dumb doing that if you do not tell exactly which 2 wires. You probably mean 2 wires of the motor.... Yep, it will work to reverse rotation...
Forum: Radio and Electronics
05-18-2024, 12:52 AM
Replies: 318
Views: 94,770
Posted By Roelof

This was measured with the v2.3 firmware the...

This was measured with the v2.3 firmware the transmitter came with. I never had the urge and need to update it, we are now at V12. I can imagine the slower 278 Hz in SR mode could be fixed in a later...
Forum: Nitro Off-Road
05-17-2024, 10:00 AM
Replies: 82
Views: 4,499
Posted By Roelof

Yes, but there is no hassle with burning up the...

Yes, but there is no hassle with burning up the starter wheel and just a few tanks with a slight rich setting is needed. If it is a rip off that is your opinion. Yes, some machines are overpriced but...
Forum: Nitro Off-Road
05-17-2024, 05:33 AM
Replies: 82
Views: 4,499
Posted By Roelof

Maybe it is a scare off price in the hope not...

Maybe it is a scare off price in the hope not much people will make a use of it. I can understand that, not much extra work and still a nice extra income.





As stated above, some people do...
Forum: Nitro On-Road
05-16-2024, 01:03 PM
Replies: 1
Views: 291
Posted By Roelof

The buttonhead needs to be placed with the 2...

The buttonhead needs to be placed with the 2 shims that normally comes with the 25% button head, so a 0.1 and a 0.15mm shim.

So they say the buttonheat provides a little bit more power. I wonder...
Forum: Nitro Off-Road
05-15-2024, 11:17 PM
Replies: 82
Views: 4,499
Posted By Roelof

Yeah, with NiCad and NiMh no problem, with LiPo...

Yeah, with NiCad and NiMh no problem, with LiPo that is different because many organisations made a rule about charging LiPo batteries in a LiPo bag. And yes, I have seen LiPo receiver batteries...
Forum: Nitro Off-Road
05-15-2024, 01:50 PM
Replies: 82
Views: 4,499
Posted By Roelof

I have seen what the JQ video can do wrong to...

I have seen what the JQ video can do wrong to people. A guy did set the gap to 0.5mm as the "ideal" gap and did tune the LSN to the wished idle and yet the engine was rich at the bottom. Adjusting...
Forum: Nitro Off-Road
05-15-2024, 05:17 AM
Replies: 82
Views: 4,499
Posted By Roelof

Today there is even more BS written, you do not...

Today there is even more BS written, you do not want to know how hard it is trying to correct false information. And yes, you can say to read the posts of old timers but then they have to use a...
Forum: Racing Forum
05-15-2024, 01:10 AM
Replies: 2
Views: 240
Posted By Roelof

Then they are on a tension, JST connectors have a...

Then they are on a tension, JST connectors have a small notch to lock itself
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.