R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: hana166
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Forum: Electric On-Road
10-02-2023, 10:48 AM
Replies: 871
Views: 173,047
Posted By hana166

Thank you Rcmax6696. I have had a few years no...

Thank you Rcmax6696. I have had a few years no racing and wanted to check my old setups, and as a result have only just found out that BobW has passed. I wrote the first Awesomatix Model, and Bob...
Forum: Radio and Electronics
04-03-2018, 11:54 AM
Replies: 1,962
Views: 421,992
Posted By hana166

The brakes on my speedo are non existent. TC 13.5...

The brakes on my speedo are non existent. TC 13.5 geared 5.2. Maclan V2 motor. Even with frequency down to 600 there's basically nothing at the end of the straight into a hairpin. Cost me 3/10 per...
Forum: Radio and Electronics
03-14-2018, 11:36 PM
Replies: 1,840
Views: 547,330
Posted By hana166

Exactly the same problem here except mine was a...

Exactly the same problem here except mine was a TC on 4.1, went to 5.2 solid blue light, corrupted, went back to 4.1 esc works fine. Now they've gone bust. Game over unless someone here knows a fix.
Forum: Electric On-Road
02-15-2018, 07:24 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Awesomatix Hard chassis for 800

Awesomatix Hard chassis for 800
Forum: Electric On-Road
02-12-2018, 08:05 AM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Very early 800 a bit tired so I gave it a refurb..

Very early 800 a bit tired so I gave it a refurb..
Forum: Electric On-Road
01-10-2017, 10:54 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Hi, a little request. If anyone has a set of...

Hi, a little request.

If anyone has a set of the original AT41 vanes I'd happily take them off your hands. Maybe someone who has upgraded might have them sitting around doing nothing.
Forum: Electric On-Road
01-10-2017, 02:28 PM
Replies: 9,898
Views: 2,223,987
Posted By hana166

If anyone has a set of original AT41 vanes, the...

If anyone has a set of original AT41 vanes, the small bore ones, please get in touch.
Forum: Electric On-Road
03-14-2016, 12:47 AM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Anyone tried hard alu chassis C01B-ALH indoor or...

Anyone tried hard alu chassis C01B-ALH indoor or outdoor?
Forum: Electric On-Road
02-28-2016, 12:22 AM
Replies: 6,819
Views: 2,051,662
Posted By hana166

No problem mate I can help you with this. Just PM...

No problem mate I can help you with this. Just PM me.
Forum: Electric On-Road
12-30-2015, 02:44 AM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Not in soft plastic mate, the plastic gives way a...

Not in soft plastic mate, the plastic gives way a bit and it actually undercuts especially with the thin wall thickness. You're standing up for your point of view no disrespect but you are plain...
Forum: Electric On-Road
12-29-2015, 04:52 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Really. If you don't have a tap..a tap costs no...

Really. If you don't have a tap..a tap costs no money especially compared to what you spend on the car, setup station etc. And everything else. If you don't have a tap buy one and learn how to use...
Forum: Electric On-Road
12-14-2015, 07:50 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Good to know, I'll try it tomorrow as I have an...

Good to know, I'll try it tomorrow as I have an all day test. Any problems I send you the bill though :)
Forum: Electric On-Road
12-14-2015, 07:04 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

Maybe I'm just paranoid but when I was building...

Maybe I'm just paranoid but when I was building my kit I made sure to fit a brace. I have had a couple of pretty big hits to the rear and am glad a brace was there holding the bulkheads together.
...
Forum: Electric On-Road
12-11-2015, 05:55 PM
Replies: 6,819
Views: 2,051,662
Posted By hana166

http://www.ebay.co.uk/itm/290990205715?_trksid=p20...

http://www.ebay.co.uk/itm/290990205715?_trksid=p2057872.m2749.l2649&var=590165438413&ssPageName=STRK%3AMEBIDX%3AIT

I weighed the sheet, measured it then calculated the mass per cubic millimetre...
Forum: Electric On-Road
12-11-2015, 05:55 AM
Replies: 6,819
Views: 2,051,662
Posted By hana166

For anyone with this issue. Regarding ballast I...

For anyone with this issue. Regarding ballast I was finding it a bit problematic having to fit about 100g to meet 1350g. I used 0.7mm and 2mm brass offcuts from ebay which were super cheap at £2. 2mm...
Forum: Electric On-Road
11-16-2015, 10:43 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

If anyone has a set of d2 dampers, not d2.1, I'd...

If anyone has a set of d2 dampers, not d2.1, I'd be OK with just the vanes and top caps, please give me a shout.
Forum: Electric On-Road
10-28-2015, 06:40 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

I am the original owner of this car.

I am the original owner of this car.
Forum: Electric On-Road
10-19-2015, 02:30 PM
Replies: 9,898
Views: 2,223,987
Posted By hana166

If you don't want to buy a GD2. Composite gears...

If you don't want to buy a GD2. Composite gears are smoother definitely. Build the diff dry and shim the sun gears 0.1mm at a time until it locks up and back off a shim. I shimmed between the sun...
Forum: R/C Items: For Sale/Trade
10-13-2015, 08:53 AM
Replies: 0
Views: 339
Posted By hana166

Awesomatix Parts

Four lots. Listed elsewhere so subject to change.

Assorted carbon, topdecks, steering arms etc £25 SOLD
Alloy baseplate, FFG 1.1, bulkhead etc £105 SOLD
Raceberry chassis carpet only £30 SOLD...
Forum: Electric On-Road
08-23-2015, 02:12 PM
Replies: 9,898
Views: 2,223,987
Posted By hana166

Agreed!

Agreed!
Forum: Electric On-Road
08-23-2015, 07:07 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

The advice from fellow posters is all correct,...

The advice from fellow posters is all correct, but you are not completely wrong. You lose grip with a stiffer car, therefore response and initial steering is less but when fully transitioned in the...
Forum: Electric On-Road
08-06-2015, 09:28 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

Well put. Anyway..the RFG. I think this is really...

Well put. Anyway..the RFG. I think this is really clever and I hope it will be a major step. With the gearboxes tied together rigidly, the forces cancel each other out but as the drivetrain is...
Forum: Electric On-Road
06-28-2015, 01:34 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

I think Steen Graverson made or tested a belt...

I think Steen Graverson made or tested a belt prototype in 2011, perhaps someone here still has a photo of it.
Forum: Electric On-Road
05-01-2015, 11:25 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

Hi Mike that stuff is awesome. I soaked the...

Hi Mike that stuff is awesome. I soaked the originals in the the Dow55 and it was a huge improvement, I just thought I'd give the silicone O rings a try.
Forum: Electric On-Road
05-01-2015, 11:01 AM
Replies: 9,898
Views: 2,223,987
Posted By hana166

I de-anodised in a plastic tub with a light...

I de-anodised in a plastic tub with a light solution of caustic soda then some sanding with 1200 grit paper wet and a block where necessary to remove milling marks then a 4 inch buffing wheel. I did...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.