tekin rs pro problem
#1
tekin rs pro problem
i have aproblem with my tekin that i cant figure out..
i have tried new sensor wires, and a new motor. re calibrating the esc a few times, and re flashing it with the hotwire..
problem is, mid run the boost cut out, now its cogging from a stand still, and barely gets going, but once its rolling it runs fine, just feels like its in blinky mode,..
and if i look closely, the 3 little leds in the tekin display that should rotate in sequence that indicate it seeing the sensor, only 2(1&3) are working..?
does this sound terminal? any ideas on how i could fix this?
thanks..
if this esc's done, so is my racing for a number of months..
i have tried new sensor wires, and a new motor. re calibrating the esc a few times, and re flashing it with the hotwire..
problem is, mid run the boost cut out, now its cogging from a stand still, and barely gets going, but once its rolling it runs fine, just feels like its in blinky mode,..
and if i look closely, the 3 little leds in the tekin display that should rotate in sequence that indicate it seeing the sensor, only 2(1&3) are working..?
does this sound terminal? any ideas on how i could fix this?
thanks..
if this esc's done, so is my racing for a number of months..
#2
raise you throttle epa a couple. I had problems with the ESC/radio not seeing full throttle and boost would not kick in or disssapear during a run