4LikesNEW HOBBYWING STOCK SUPERCHARGED SOFTWARE
06-30-2010, 09:41 AM
#616
Hi, how can we tell if we have the new 120A 2.1 with the upgraded MOSFET board? I am looking to get one at the shop now and the shop doesn't know anything about the board except that they received the stock about 3 weeks ago. Thanks.
Hi Guys
There are more products being released at the same time as the xtreme stock .
example the 120 amp 2.1 with has an upgraded mosfet circuit board.
120 amp 1S single
the new short course truck combo .
Justock 45 amp esc with no timing
so please patient
If anyone needs software/firmware please email me at [email protected] dont download from file factory hobbywing does not recomment it .
so guys please be patient .
thank you for your time
Angelo hobbywing tech dir.
There are more products being released at the same time as the xtreme stock .
example the 120 amp 2.1 with has an upgraded mosfet circuit board.
120 amp 1S single
the new short course truck combo .
Justock 45 amp esc with no timing
so please patient
If anyone needs software/firmware please email me at [email protected] dont download from file factory hobbywing does not recomment it .
so guys please be patient .
thank you for your time
Angelo hobbywing tech dir.
06-30-2010, 10:02 AM
#617
Ok, I checked the rotor and it is not spinning on the shaft and I took the bearings out, cleaned them and reoiled them and now the sound of the motor has changed to a very low buzz. Like the bzzzzz of a bee. It seems ok, so I guess I will keep driving it until it breaks. Thanks for the help...
You may have a bent rotor shaft? Loosen the three screws at the front of the motor about one to two turns then spin the rotor by hand. The end cap of the motor housing will wobble if the rotor shaft is bent.
I bent one on a 550 size motor (4.5t) on my Hyper SC10. I was doing insane, stupid, crazy jumps. It now makes a buzz sound.....
06-30-2010, 10:44 AM
#618
Ok, I checked the rotor and it is not spinning on the shaft and I took the bearings out, cleaned them and reoiled them and now the sound of the motor has changed to a very low buzz. Like the bzzzzz of a bee. It seems ok, so I guess I will keep driving it until it breaks. Thanks for the help...
Just a note on your hassle, sometimes when you overheat a motor the rotor gets so hot it loses magnetic strength, this causes a funny whining noise when you drive it but will also make the motor get hot and in some cases the esc will get hot too.
Seeing that it did get quiet ofter oiling the bearings, replacing them looks like the answer to your particular hassle.
06-30-2010, 10:50 AM
#619
Have been blanked twice on the SP thread so they dont know..
Wondering if anyone can advise me in here.
Bascially im running 528/518 software and have just started 10.5 from a coupld of years in modified.
Anyone have a starting setup that i could use....its for a medium length outdoor track...straight around 55m.
Thankyou
Steven
Wondering if anyone can advise me in here.
Bascially im running 528/518 software and have just started 10.5 from a coupld of years in modified.
Anyone have a starting setup that i could use....its for a medium length outdoor track...straight around 55m.
Thankyou
Steven
06-30-2010, 03:54 PM
#620
Have been blanked twice on the SP thread so they dont know..
Wondering if anyone can advise me in here.
Bascially im running 528/518 software and have just started 10.5 from a coupld of years in modified.
Anyone have a starting setup that i could use....its for a medium length outdoor track...straight around 55m.
Thankyou
Steven
Wondering if anyone can advise me in here.
Bascially im running 528/518 software and have just started 10.5 from a coupld of years in modified.
Anyone have a starting setup that i could use....its for a medium length outdoor track...straight around 55m.
Thankyou
Steven
https://docs.google.com/viewer?url=h...-Hobbywing.pdf
06-30-2010, 07:48 PM
#621
.
07-01-2010, 02:42 PM
#622
i'm new guy here...
HW v2.1 is the upgraded version
so all of v2.1 are upgraded from v2.0
to handle more load but unnecessary
for motor 8.5+.
to check, you can see the wiring position
they aren't same compare with v2.0.
v2.0 the battery + - stay together
but v2.1 isn't
07-01-2010, 09:19 PM
#623
Tech Apprentice
Hi all.
i'm new guy here...
HW v2.1 is the upgraded version
so all of v2.1 are upgraded from v2.0
to handle more load but unnecessary
for motor 8.5+.
to check, you can see the wiring position
they aren't same compare with v2.0.
v2.0 the battery + - stay together
but v2.1 isn't
i'm new guy here...
HW v2.1 is the upgraded version
so all of v2.1 are upgraded from v2.0
to handle more load but unnecessary
for motor 8.5+.
to check, you can see the wiring position
they aren't same compare with v2.0.
v2.0 the battery + - stay together
but v2.1 isn't
So you've seen a version 2.1?
Where did you see it?
Thank you
Joe
07-01-2010, 10:19 PM
#624
i'm not have seen but i've been using it...
both v2.0 and v2.1 and also Xtreme stock.
More than 5+ people that own v2.1 already
since 2 weeks ago...
thanks
07-02-2010, 06:20 AM
#625
Tech Regular
New Brushless ESC
Hi everyone...it's been a while since I last posted!
Anyway, I am running a trusty old Noval GTB in my 1/12th and the cars is great to drive, but I'm getting blitzed on the straights as I don't have dynamic timing.
So... I'm in the market for a new ESC... I really like the look of the LRP SXX StockSPec but can't afford it. Ditto for the Tekin RS and the GM...
But the HobbyWing XERUN 120SD looks really good for the price.
How does it compare on the track to the "major brands"?
Is the timing dynamic (turbo / boost functionality)?
What version 60A / 120A should I go for for 10.5 1/12th racing?
Software version...?
Am I wasting my money getting one of these...should I save up my money for something more mainstream?
Sorry for all the questions, but seems like a intelligent audience
Anyway, I am running a trusty old Noval GTB in my 1/12th and the cars is great to drive, but I'm getting blitzed on the straights as I don't have dynamic timing.
So... I'm in the market for a new ESC... I really like the look of the LRP SXX StockSPec but can't afford it. Ditto for the Tekin RS and the GM...
But the HobbyWing XERUN 120SD looks really good for the price.
How does it compare on the track to the "major brands"?
Is the timing dynamic (turbo / boost functionality)?
What version 60A / 120A should I go for for 10.5 1/12th racing?
Software version...?
Am I wasting my money getting one of these...should I save up my money for something more mainstream?
Sorry for all the questions, but seems like a intelligent audience
07-02-2010, 08:02 AM
#626
Tech Apprentice
Hi everyone...it's been a while since I last posted!
Anyway, I am running a trusty old Noval GTB in my 1/12th and the cars is great to drive, but I'm getting blitzed on the straights as I don't have dynamic timing.
So... I'm in the market for a new ESC... I really like the look of the LRP SXX StockSPec but can't afford it. Ditto for the Tekin RS and the GM...
But the HobbyWing XERUN 120SD looks really good for the price.
How does it compare on the track to the "major brands"?
Is the timing dynamic (turbo / boost functionality)?
What version 60A / 120A should I go for for 10.5 1/12th racing?
Software version...?
Am I wasting my money getting one of these...should I save up my money for something more mainstream?
Sorry for all the questions, but seems like a intelligent audience
Anyway, I am running a trusty old Noval GTB in my 1/12th and the cars is great to drive, but I'm getting blitzed on the straights as I don't have dynamic timing.
So... I'm in the market for a new ESC... I really like the look of the LRP SXX StockSPec but can't afford it. Ditto for the Tekin RS and the GM...
But the HobbyWing XERUN 120SD looks really good for the price.
How does it compare on the track to the "major brands"?
Is the timing dynamic (turbo / boost functionality)?
What version 60A / 120A should I go for for 10.5 1/12th racing?
Software version...?
Am I wasting my money getting one of these...should I save up my money for something more mainstream?
Sorry for all the questions, but seems like a intelligent audience
get HW V2.1 or xtreeme stock if it available..
my HW 120 V2.1 can eat Tekin for Lunch,LRP SS for Breakfast and GM for Dinner...
my local racers used those 3 escs above (and they know how to set up an ESC
)
07-02-2010, 09:13 AM
#627
Tech Regular
XERUN v2.1
Seems like the 2.1 is the beastie to get then.
Any idea on price and availbility ? I guess I need to mail order as there is no UK retailer (Schumacher have the Speed Passion range and there is no cross competition unlike LRP/Nosram)
Dave
Any idea on price and availbility ? I guess I need to mail order as there is no UK retailer (Schumacher have the Speed Passion range and there is no cross competition unlike LRP/Nosram)
Dave
07-02-2010, 11:54 AM
#628
I don't know where you live....
but I think you can check in Canada.
About the price v2.1 in Thailand is around
130 USD. (Speedo only) and they available.
Preay.
07-02-2010, 12:38 PM
#629
Tech Master
07-02-2010, 12:56 PM
#630
Hi Guys.......
Some linky's to sellers would be awesome as we are all waiting for these to become available so if anybody knows where to buy them from then please post links for the 2.1 and the Extreme Stock.............
Some linky's to sellers would be awesome as we are all waiting for these to become available so if anybody knows where to buy them from then please post links for the 2.1 and the Extreme Stock.............