engine for MT12 p/s and crank
 

I have a piston and sleeve with conrod and SG crankshaft for MT12. What engine/s will these fit besides mugen MT12?

Top TT 12 S1

I think all the Nova based side exhaust engines (except HPI Evo2) are long rod engines and will be able to use those parts.

well almost. the piston, sleeve and crank will fit rear exhaust nova type 12,(pre NS and V12 RB) The sleeve can be used in a side port if the alignment pin is removed from the case. the crank will also fit the side port The rod will only fit the MT or a side port nova engine (non hpi evo) Tall deck type.

Since we're on the subject, will a MR12 conrod fit the RBX12? how about the MT12?

yes on the rb no on the mt

so I can use MT12 p/s with conrod and crank on rb rody x12 right?

Noooo, you can use everything but the rod.

Again:

All nova rossi parts are interchangeable, but the rods.

MT12, Top TT12 and NR side exhaust engines have the long conrod, every other engine from NR has a short rod.

Re: engine for MT12 p/s and crank
 

NOVA S5 will exactly fit.

except the rod....

head button
 

anybody know if a pico/ofna x-12 head button will work on a mr12 took measurments this morning and the only thing i found was the deck height dia. was 0.01 bigger 13.78 nova to a 13.79
pico ,

Re: head button
 

Yes. I had to use a Nova Head button on a Picco-Collari and worked just fine, no problem, so i guess the other way around should be fine to.
AFM

head buttons
 

thks afm.:p