parts swapping from other 1/10 on road kits
#1
parts swapping from other 1/10 on road kits
has any body tried this to make there car run better or just something different? we all know each maufacture has there on design on different parts but have the same fuction. i have a mtx4r and was looking at the shepherd velox10 rear and brake set up and some the capricron lab-co1 parts that could possible work on the mtx4r possibly creating a new car . just somethings that i was thinking about . any input
Last edited by tman45; 05-18-2010 at 04:06 PM. Reason: clean up
#2
.. also be good if someone found a smaller diff that can fit the RRR...
#3
Ofcourse is this possible within the limits of your knowledge and creation. I know some people are playing with other brands suspensionparts and fueltanks but placing a complete rear part from a V10 on a MTX4 will not fit, a new homemade chassisplate is needed. If the V10 rear axle will fit on a MTX4 you do need to create the braking system on the MTX bulkheads.