Steering would not throw 100%...
01-02-2002, 07:35 PM
#1
Steering would not throw 100%...
I'm wondering if any of you have had the same problem...
All of a sudden my steering would not throw 100% on either direction....I have an older FM Futaba....all the controls are mechanical....I have adjusted the Steering ATV to 100% but it still would not do it....
I recall it used to throw more than it does right now...because I even had to adjust the Left ATV so the tire would not hit the pipe.
The servo works fine...I tried using a different radio with it.
All of a sudden my steering would not throw 100% on either direction....I have an older FM Futaba....all the controls are mechanical....I have adjusted the Steering ATV to 100% but it still would not do it....
I recall it used to throw more than it does right now...because I even had to adjust the Left ATV so the tire would not hit the pipe.
The servo works fine...I tried using a different radio with it.
Last edited by got_speed?; 01-02-2002 at 10:49 PM.
01-02-2002, 07:54 PM
#2
Is your servo horn stripped?
01-02-2002, 08:20 PM
#3
The servo is fine....I unplugged the servo and hooked it up to a different RX & TX it works just fine.....
I've pretty much isolated it to the radio system....just could not tell if I'm missing anything other thant he ATV or ATL adjustment that's already set to 100%...
I've pretty much isolated it to the radio system....just could not tell if I'm missing anything other thant he ATV or ATL adjustment that's already set to 100%...
01-04-2002, 08:26 PM
#4
If you set EVERYTHING back to factory - 100% then I would say your radio is bad. You mentioned that you used a different radio and receiver on the servo and the servo worked fine. Did you use the new radio with the old receiver? Last check to make sure it isn't the radio but maybe the receiver.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
