Manticore

no no, i saw people bend the stock shaft in the first run......

Jack

like what u say
must be the driving.. must be the driving

calimassive

yeah, must be the driving.... I cant imagine that part bending on the first run, unless there was a seriously gnarly accident, but even then...

Manticore

we have been saying about the quality of the shaft, havent we?

calimassive

So your saying the quality of the shaft is not good. Your the only one claming that. Is that what your saying? No offense but, sometimes I have a hard time understanding some of your posts. Not your last post though. Sometimes I get confused by Jack's posts too.

calimassive

To install the K factory tank, you have to drill a hole in the stock deck. So my question is, what size drill bit should be used? I've never used a dremel tool before. Would that do the job?

Jack

calimassive

so its bad quality in your guys opinion or no???

Manticore

you might like to test it yourself ! i wont! and i am not using the stock shaft.

calimassive

Oh ok, what kind of shaft are you using? Have you had bad experiences personally with the stock one? I'm assuming you have cause your not using it.

Manticore

i am not going to answer any un-ended questions. it seems you were to derive a simple question into complicated one.

calimassive

huhh?? ok, Manti, never mind then, jeeeze, no need to be a jerk, thanks man

Anyways, if one was to get the low cg k factory tank and the kawahara low cg engine mounts, other than the servo, would the MTX-3's cg be that much lower than the V1RR's? I'd imagine it wouldnt be that big of a difference then. But im not sure.

Jack

hmmm
my shaft is custom made , hollow in the center
......so i dont really know about the stock one....
manitcore shaft is custom made too......

calimassive

Thanks Jack for clearing that up... I dindt mean to be rude by asking so many questions, or saying that i couldnt understand you and Manti's posts sometimes. I think you guys type fast and type in short statements and plus im a newbie, so I dont know all the lingo yet... I apologize..

HEYALIGNMENTGUY

Calli I thought you where not interested in the K Tank.