Xray NT1
#5388
Tech Master
iTrader: (2)
Also had to cut a groove were the wire sits in and drill 2 holes with m3 thread for the wire.
The upper part of the bulkheads didn't need modification.
Also made 4 holes with m3 thread on the sides of the lower and upper bulkhead to mount two carbon brackets for stiffness.
When I really like the system and it is faster as the stock system I will have a set of bulkheads and the carbon parts machined professionally, now I did everything with a dremel tool.
#5389
upgrade parts for USD100 budget
hi guys need ur help here...
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
#5390
hi guys need ur help here...
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
#5391
Tech Elite
iTrader: (15)
hi guys need ur help here...
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
i have USD150 to spend at RCMarket, im looking for wise upgrade for the money. would someone plz list down which parts should i order for my stock NT1 2010, to improve my car performance/ durability?
* oppps now my balance to spend is only USD100 coz i need to order CSO 3.1mm 7075 hardcoated chassis to replace my slightly bent chassis.
-to exclude wheel hub coz already upgraded
lightweight middle shaft
lighteight front shaft
yellow clutch shoe
light weight brake disk adpater
1 degree front knuckle arms
0.7 front sway bar soft
km racing brake pads
#5392
Umm, what about the lightweight clutch bell?
#5395
Thanks guys for the ideas... it will make my decision easier. i'll have a look at those items & see if i need to stretch my budget a bit. regarding alu clutch bell, anybody here have same experience as TomB?
#5397
XRAY Released 2 option parts
& Low Friction belt V2
& Low Friction belt V2
Last edited by RC MARKET; 06-28-2010 at 08:04 AM.
#5398