Serpent 720
#3557
thank's i was usuing the front one....
#3559
hi paolo, dj and gianni,
How often do you guys change clutch-shoe(red)?, do guys change every qualifying? and a new one for the mains, or you keep it there as long as its working? One more thing, do guys use part no. 1388 for the thrust bearing with 6 ceramic balls or the the one with 10 balls? Is there any difference?
TY in advance
How often do you guys change clutch-shoe(red)?, do guys change every qualifying? and a new one for the mains, or you keep it there as long as its working? One more thing, do guys use part no. 1388 for the thrust bearing with 6 ceramic balls or the the one with 10 balls? Is there any difference?
TY in advance
#3560
#3561
Tech Elite
hi paolo, dj and gianni,
How often do you guys change clutch-shoe(red)?, do guys change every qualifying? and a new one for the mains, or you keep it there as long as its working? One more thing, do guys use part no. 1388 for the thrust bearing with 6 ceramic balls or the the one with 10 balls? Is there any difference?
TY in advance
How often do you guys change clutch-shoe(red)?, do guys change every qualifying? and a new one for the mains, or you keep it there as long as its working? One more thing, do guys use part no. 1388 for the thrust bearing with 6 ceramic balls or the the one with 10 balls? Is there any difference?
TY in advance
DJ Apolaro
#3565
Tech Initiate
rear bulkhead
do you guys get problem in rear bulkgead of getting loose.
do you have any solution on it?
do you have any solution on it?
#3566
Tech Initiate
[QUOTE=rcabj;4407588]i know like has been mention above the default setting around 1.5 - 1.8.
out of curiosity , how much less ( i mean tension less than the above ) has anyone here gone to with their setup , or 1.5 is the min everyone uses...thanks
It really depends on what type of track you are running. If the trrack has no grip at all you can even run lower than the base setting. However, if you are running on a high grip track, then you can may try even tighter. You have to feel the car by holding it down and applying throtle on it. it should then feel very hard to drive when you are racing. Or else you timng will be off.
out of curiosity , how much less ( i mean tension less than the above ) has anyone here gone to with their setup , or 1.5 is the min everyone uses...thanks
It really depends on what type of track you are running. If the trrack has no grip at all you can even run lower than the base setting. However, if you are running on a high grip track, then you can may try even tighter. You have to feel the car by holding it down and applying throtle on it. it should then feel very hard to drive when you are racing. Or else you timng will be off.
#3567
Tech Elite