jboquire

iTrader: (21)

It is the same. Im sure that will change once the 7TR comes out.

jb

korneevtv

When 7TR will release?

OfnaJoe

iTrader: (58)

Can you underdrive a X7T like you can the buggy with different gearing ? I did my buggy and love it and want to do my truggy, just can't find any other gearing

DaveMBX6T

What is underdrive mate?

DaveMBX6T

One more Q.
On page 11 reference is made to a "cunk tank mod", what is this?

curacing2

Underdrive is running a lower gear ratio in the rear, it's meant to help rear grip by the front getting more drive than the rear, this truggy and the 6T do not need it from my experience, the centre diff does it already and can be controlled to a certain extent with heavier or lighter diff oils.

The clunk in the tank is a mod some do so the fuel pickup in the tank still gets fuel when they're upside down.

DaveMBX6T

Thanks Curacing2.

OfnaJoe

iTrader: (58)

still would like to know if it's a optional gear to do it with, I can't find it.

DaveMBX6T

Had my 7T diffs on:
Front 10K
Centre 15K
Rear 5K

It was very lively and aggressive and hurt my lap-times.
Then changed it to 10/10/5, now its more controlled/tamed.

Any opinions?

jmaxey51

iTrader: (7)

No, they do not offer it for truggy.

curacing2

That's what I run Dave 10 10 5, works well in all conditions.

Craig.

aloksatoor

iTrader: (43)

In the market for a truggy for summer. When is the mbx7tr due? Its this or the strr but they seem to be stopping that one.

coombes

iTrader: (6)

I am looking to buy mbx6tr off here will the sworkz truggy arm fit it as they do for the 7t

curacing2

Yes, I am running 7T arms on my 6T, they are 1mm thicker so about 10% stronger, the sworks do look stronger again.

invrtd

iTrader: (29)

Didn't buy the non taper pistons. But those of you using stock pistons, did you run the tapper down to get more pack and better rebound? Have my new truggy built minus shocks and motor install. Any insight is appreciative.