Frank L

iTrader: (148)

I have been using a DX3R for quite awhile, pretty much a few months after it came out. I experienced an issue yesterday that I did not expect. The transmitter worked fine in the morning at practice and then when quals started model #2 on the transmitter just stopped working. I thought it needed to be re binded but it would not bind, I checked the receiver with a backup and still same thing it would not bind, finally a buddy suggested that I try a different model # on the transmitter and that was it. I know I can send it back and they will take care of it, but I was wondering if anyone had a similar issue and if it got worse or if it just stayed with 1 non-working model?

mugendriver23

iTrader: (8)

I had one do the same thing. I kept trying for 2 weeks after it happened and it never worked so I sent it in. Maybe try the Radio/Electroncics thread. Someone might know in there. Good luck

carlosm

iTrader: (17)

Frank Check this out: http://www.spektrumrc.com/Articles/A...ArticleID=1784

mugendriver23

iTrader: (8)

Well I thought Frank said he tried to re bind it again but nothing happened. So im not sure that article is what he is looking for because it just tells you to rebind the radio and receiver.

Jonathan Bell

iTrader: (15)

Frank I think there is an option there somewhere to do a master reset. It will reset all your epa's and such but it would be worth a shot. This is just an idea and I haven't tried it. If that doesn't work I'm not sure your gonna get the answer here and you probably should just send it in.

Frank L

iTrader: (148)

Anks guys for the response. Ya I did try to rebind and try and try it's like that model # just died. I just don't want it to get worse. I'll try the radio/ electronics section thanks.