STARTER BOX BATTERY QUESTION
#1
Tech Regular
Thread Starter
STARTER BOX BATTERY QUESTION
I have 2 Losi 7.2volt 3600mAh 6 cell NiMH batteries here and was wondering what the discharge rate is for them is. I was also wondering when they should stop discharging and start charging. You know like how far it will go until it starts charging. (i.e.-4.5volts)
#2
Tech Master
Depends what your charger can discharge at,it will have a limit.I wouldnt discharge a full pack at over 5 amps though or by the time their done they will be very,very hot. AS for a cutoff voltage standard is 0.9v per cell or 5.4v per pack. I am assuming since you said 7.2v pack you have nimh or nicd batts.In case you ment 7.4v as in lipo dont discharge below 3.2V per cell or 6.4 per pack to be safe.
#3
Tech Regular
Thread Starter
[QUOTE=butch man;6303091]Depends what your charger can discharge at,it will have a limit.I wouldnt discharge a full pack at over 5 amps though or by the time their done they will be very,very hot. AS for a cutoff voltage standard is 0.9v per cell or 5.4v per pack. I am assuming since you said 7.2v pack you have nimh or nicd batts.In case you ment 7.4v as in lipo dont discharge below 3.2V per cell or 6.4 per pack to be safe.
[/QWould two amps be good? I have NiMH batteries.
[/QWould two amps be good? I have NiMH batteries.
#4
2 amps is ok, i charge mine at 1.5 if im not in a hurry
#5
Tech Regular
Thread Starter
I mean would discharging at 2amps be alright
#6
Tech Master
Yes 2 amps discharge is ok it will just take a long time.
#8
Tech Regular
Thread Starter
That wont damage the batteries will it? Id rather wait than rush and ruin them.