Adam Drake talks about the new 8ight 2.0
#211
any 2.0 owner's have any issues with the radio tray and getting it Over far enuff to screw it down ?.....i had to do a little modding to the dirt guard to let the base of the servo sit properly....i called horizon on it and buddy claimed its a First for him.
#215
Tech Fanatic
CRAP! I just got busted out by the Alabama gang. Have fun Losi lovers.
#217
it was a mm or so.....take a loook at your tray and see how Close the servo sits to the dirt guard....its close if anything....and mine wouldn't fit worth a bean...basically the tray rocked back and forth on that one point and i could get in either 1 top screw or 1 bottom...but then it would throw out the other holes.....and i traced it back to the Dirt guard....shaved it slightly and everything fit.......maby its the servo ?
#218
it was a mm or so.....take a loook at your tray and see how Close the servo sits to the dirt guard....its close if anything....and mine wouldn't fit worth a bean...basically the tray rocked back and forth on that one point and i could get in either 1 top screw or 1 bottom...but then it would throw out the other holes.....and i traced it back to the Dirt guard....shaved it slightly and everything fit.......maby its the servo ?
part no
losa4426
http://www.amainhobbies.com/product_...oducts_id/7733 there are 4 of them in this pic
there is a table on page 23 of the 2.0 manual that tells you what servo (5 main brands) require them
hope that helps Adrian
#219
No radio tray fitment issues here; running Futaba servos.
So far my issues have been: Diff fluids swapped f/r relationship (no biggie); BUT the major issue thus far is....NO CLUTCH NUT PACK...so no clutch nut; collet, bearings or shims.
So far my issues have been: Diff fluids swapped f/r relationship (no biggie); BUT the major issue thus far is....NO CLUTCH NUT PACK...so no clutch nut; collet, bearings or shims.
#220
#222
did you use the 2mm servo spacers that come with the kit they are supplied for that exact reason, well they come with the 1.0 kit don't know about the 2.0 raceroller.
part no
losa4426
http://www.amainhobbies.com/product_...oducts_id/7733 there are 4 of them in this pic
there is a table on page 23 of the 2.0 manual that tells you what servo (5 main brands) require them
hope that helps Adrian
part no
losa4426
http://www.amainhobbies.com/product_...oducts_id/7733 there are 4 of them in this pic
there is a table on page 23 of the 2.0 manual that tells you what servo (5 main brands) require them
hope that helps Adrian
the chart blatently stated to Not use a washer for any Futaba servo's....therefor i didnt....im going to double check it right now....but im almost 100% positive it said No shim.
#223
#224
#225
I went back and looked at mine again...its VERY close and you might *think* its hitting; but its probably just *barely* touching the innermost edge of the side guard. Its not sitting on it though; nor did the servo prevent the side guard from becoming installed properly.
I will likely take the Dremel and lay the edge back so it doesn't go over and start banging the servo case
I will likely take the Dremel and lay the edge back so it doesn't go over and start banging the servo case