R/C Tech Forums

Go Back   R/C Tech Forums > Members List

22Racer 22Racer is offline

Tech Elite

Visitor Messages

Showing Visitor Messages 1 to 10 of 25
  1. DrGladwin
    06-02-2016 09:15 PM - permalink
    DrGladwin
    Hi Rex,

    I'm having the following issues with my engine:

    - very difficult to prime
    - glow plug burns immediately as soon as I hit WOT
    - very erratic idle
    - idle sounds very different. Not sure what it is, but it's not what it used to me. I only put 1 gallon through the engine.

    Is it time for a rebuild? This is a HPI nitro star F3.5 engine.

    Thank you!
  2. animalnz
    09-11-2014 06:48 PM - permalink
    animalnz
    Hi Rex, Stephen Bowles is a mate of mine here in NZ and he has recommended you. I am looking for a decent engine that is on the easier side to tune. I have been looking at the FX range and have had a good run with speeds. Also i really struggle to get much time to run in so wondering if you do that as well? Cheers Ben NZ
  3. raggedwarrior
    03-08-2014 02:42 PM - permalink
    raggedwarrior
    Hey bud I have a few GRP .21 engines that need rods I have seen u know a lot about all types of off road engines do u know of another engine that use the GRP style rod I am pretty sure it's 29.50 mm from hole to hole I found some but there overseas and not cheap thank you for any help u can provide
  4. imrob
    12-17-2013 03:45 PM - permalink
    imrob
    ...
  5. 22Racer
    05-27-2013 05:00 PM - permalink
    22Racer
    these are Ross Mutschlers engines. paypal is [email protected] you can also e-mail me at that address
  6. ddtjr
    05-27-2013 04:56 PM - permalink
    ddtjr
    Ok sounds good I will take the one for 120 just send me your Paypal info. This is donnie btw I'm getting back into nitro
  7. ddtjr
    05-27-2013 12:25 PM - permalink
    ddtjr
    What fuel was run in those motors?
  8. bubba450
    01-02-2013 10:54 AM - permalink
    bubba450
    do you still the ad2 thanks
  9. zmetal
    07-18-2012 09:23 AM - permalink
    zmetal
    Rex sent the 2 VZB last weekend wanted to confirm reciept
    ZMETAL
  10. pranash07
    06-15-2012 02:23 PM - permalink
    pranash07
    Hi 22 do you still do motor pinching on a .12 ? Mega12MF 3P

About Me

  • About 22Racer
    Location
    Wanamingo Mn
  • Signature
    Rw modding and engine repair http://www.rw-mods.com
    Sleeve resizing $15.00/ motor rebuild $30.00
    Argus engine distributor/Avid bearings/ Alpha engines/
    Fx Royal engines/ Maxy Engines
    e-mail [email protected] Rex Welch

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 11-14-2017 08:03 PM
  • Join Date: 03-30-2002
  • Referrals: 0

Friends

Showing Friends 1 to 10 of 24

All times are GMT -7. It is currently 10:31 AM.


Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net