Adapting Pan Car or F1 wheels (F & R) to 1/10 sedan ?
#16
Oreo, I must admit, I like this idea better, looks like I have to locate some #4114. Beautiful work !
I put a body on the narrow Pan Car rear on fronts and rear Pan Car on rears setup, it look a bit strange as the adapters really push the wheels out to the extreme in front :
The rear of the body wouldn't look high if I trimmed the body a bit to clear the chassis mounted diffuser
I put a body on the narrow Pan Car rear on fronts and rear Pan Car on rears setup, it look a bit strange as the adapters really push the wheels out to the extreme in front :
The rear of the body wouldn't look high if I trimmed the body a bit to clear the chassis mounted diffuser
#17
Pan Car wheels on TC
This is another a combination of recommended applications. CPR rear wheel adapters in the rear and rear 1/10 nitro ( 30mm ) in the front :
Now this combination doesn't seem TOO ridiculous and may actually fit under some bodies w/ fender flares .
Now this combination doesn't seem TOO ridiculous and may actually fit under some bodies w/ fender flares .
#19
wheel adapters
I know this is a old post but where did you get those front and rear adapters to 1/10 touring car from
#20
Just out of curiosity (because I have never tried), but is there a specific reason why Nitro foam TC tires wouldn’t work? Are the offsets not the same? I’ve seen them available in 26 and 30mm widths, but have never ventured beyond that.