Rogue_Texan

iTrader: (15)

Ok my Sprint 2 is acting odd, I was driving it and then it went to half power forward and full power reverse. I am using all the stock electronics that come in the rtr-x. I am running it on NIMH that came in the box, sc 15 wp esc, firebolt 15t motor, and the stock hpi servo if that matters or helps. Any ideas would be greatly accepted.

ThePanda

iTrader: (68)

Try resetting the esc endpoints.

Geezatec

Recalibrating The ESC should be in your manual.

Rogue_Texan

iTrader: (15)

Right on that was where I was headed next as I see nothing loose or rubbed/chafed. Thank you guys very much.

Rogue_Texan

iTrader: (15)

Ok quick question for you guys. Woke up this morning ready to reset end point and all that jazz but just for sh!ts and giggles tried it real quick and it was back to normal. WTH? On another note I got most of my lights installed last night.

ThePanda

iTrader: (68)

It was a ghost! Haha, glad it is working again.

Rogue_Texan

iTrader: (15)

So am I, I love this thing now on to setting it up

Geezatec

you installed your lights, you probably charged your NiMh's, batteries was discharged.

Rogue_Texan

iTrader: (15)

I did not charge them between the problem arising and trying it again after ther lights were hooked up so I am going with it was a ghost. Thanks for the help guys.