Can any ESC be used with 1s?
#1
Can any ESC be used with 1s?
I have searched and seen this asked on many threads but can't seem to find a clear cut yes or no answer. I want to be sure before I pick up an ESC.
Can any standard brushless ESC that is not designed for 1s be used with a 1s pack as long as either an external booster or Receiver pack is used?
Thanks,
Rob
Can any standard brushless ESC that is not designed for 1s be used with a 1s pack as long as either an external booster or Receiver pack is used?
Thanks,
Rob
#3
Tech Fanatic
Most of the modern speedos do with a regulator for the receiver,
#5
Ok, so the booster or receiver pack is not just boosting the voltage for the servo it is also boosting the esc because the computer needs higher voltage to do it's thing. I think i got it now.
Also I seen a diagram on here for wiring a receiver pack for a 1s setup, but can't seem to find it. Anyone have the link?
Also I am running 1/10 pan with 10.5 what receiver pack specs are recommended. life, lipo, mah rating?
Thanks for the info,
Rob
Also I seen a diagram on here for wiring a receiver pack for a 1s setup, but can't seem to find it. Anyone have the link?
Also I am running 1/10 pan with 10.5 what receiver pack specs are recommended. life, lipo, mah rating?
Thanks for the info,
Rob
#6
Tech Champion
iTrader: (4)
I run Novak- Edge or Havoc Pro SC with X Drive. Both are for 2 cells but I have run them in World GT and Legends with one cell. The Booster works fine with either (Novak). or you can run a reciever pack- LIFE. If you get a Kinectic they like a reciever battery pack (life).
#7
Ok, so the booster or receiver pack is not just boosting the voltage for the servo it is also boosting the esc because the computer needs higher voltage to do it's thing. I think i got it now.
Also I seen a diagram on here for wiring a receiver pack for a 1s setup, but can't seem to find it. Anyone have the link?
Also I am running 1/10 pan with 10.5 what receiver pack specs are recommended. life, lipo, mah rating?
Thanks for the info,
Rob
Also I seen a diagram on here for wiring a receiver pack for a 1s setup, but can't seem to find it. Anyone have the link?
Also I am running 1/10 pan with 10.5 what receiver pack specs are recommended. life, lipo, mah rating?
Thanks for the info,
Rob
#9
#10
I could not get a Hobbywing Xerun 60A to work with 1S. I had to plug in a 7.4V source in order to turn off the voltage cutoff. I also couldnt get the supercharge software to run with boost and turbo.
I was using a Novak Smartboost, not a RX pack though..
I was using a Novak Smartboost, not a RX pack though..
#11
#12
i run the 60 amp Extreme Stock speedo with 1S, i use a 800mAh 2S lipo rx pack. you use a 2S pack to turn off the voltage cutoff (you can use the rx pack to do this). then upgrade the software to 508. I ran this combo with boost and turbo at the US Indoor Champs and it worked great.
#13
The 1S Hobbywing has an internal BEC that doesn't require a booster or RX pack. These are available at Lefthander RC or CRC.