chunked foam

Hey guys, while doing some spirited driving on my street, my rear left tire took the impact while my TA05V2 slid sideways into a 1:1 tire. The impact was nothing crazy, 10-15 mph and rapidly decreasing in speed since I was sideways on rubber tires. The camber link tore out of the plastic. Thinking nothing of it, I adjusted camber and simply used a different mounting hole. I did notice some wheel wobble, which was very mild.

Now, depending on my servo trim on my radio, I either have a pull to the left off-throttle OR a pull to the right on-throttle. It's pretty annoying.. can a bent axle shaft cause this? I took out the axle shaft and you can see the bend, but it's minor. No exaggeration. My toe and camber seem to be untouched on my front wheels..

Thanks a lot!

MattFromSooke

did you change holes on both sides?

chunked foam

I did that. Everything is symmetrically mounted. Don't know what else could be wrong, my camber is fine in the rear.

theatriks

iTrader: (8)

what kind of servo .....ive noticed with my cheapy 15$ futaba 9003s that it has trouble getting back to neutral setting so that might be an issue.