TRF Tools with Hudy Tips... can it be done?
#3
Re: TRF Tools with Hudy Tips... can it be done?
Originally posted by Runin Ronin
Hey Guys, So I broke the tip off of one of my TRF Allen drivers. Can I put in a replacement HUDY tip on it? Anyone tried this?
Thanks,
John
Hey Guys, So I broke the tip off of one of my TRF Allen drivers. Can I put in a replacement HUDY tip on it? Anyone tried this?
Thanks,
John
#5
Thanks heirog, I knew you'd give me a hard time. Tamiya is closed for the holiday, I'll call them on Tuesday. I am just figuring if the HUDY tips fit, then I'll go fot them since (from what I understand) the Hudy tips are made of steel and the TRF tips are made of aluminum. Someone correct me if I'm wrong.
#6
Re: Re: TRF Tools with Hudy Tips... can it be done?
Originally posted by forty6
Measure the shaft of the TRF tool and what size of the tip and I can compare it to my Hudy.
Measure the shaft of the TRF tool and what size of the tip and I can compare it to my Hudy.
I just now had the time to take a pic:
The width of the shaft is .118 (3mm)
and if it matters, I broke the 1.5mm tip.
Thanks for your help.
John
#7
The shaft diameter on the Hudy is 2.98mm, so it should fit the TRF handle just fine. It is also a 1.5mm tip by the way. It also has a flat spot for the set screw. Hope this helps.
#9
#10
ashfordhobby.com has good prices on Hudy stuff as well.
Rob
Rob