Hot Bodies TCX
#121
a fantastic win for hara. now let's see how the car will perform in the world's warm up race. hopefully ronald volker will be taking part (or is he going to the reedy race like marc and viktor?). it'll be good to see some comparison on a smaller asphalt track where horsepower doesn't matter as much.
kyew still thinking whether to get a yok or HB?
#122
i managed 16.5 at BK's on sorex last weekend. i believe i can still extract more from my current car with a bit of setup and driving adjustment. therefore will only move to a new car when i think the current one is holding me back from going even faster. anyway the tcx is not released yet, the yok is very expensive locally, plus the twin star brand is still fast in the corners at the ETS, so........
#124
Anybody know if the lipos with the "humps" on the bottom will fit?
any further news on a release date, was going to update from the TC to an Xray T3 but like the look of this, so may hold off for the TCX
any further news on a release date, was going to update from the TC to an Xray T3 but like the look of this, so may hold off for the TCX
#125
#126
Tech Regular
#127
For the bullet plugs..drill a hole through to the other side, then turn the pack over and neaten it up...
Works for me with a Exotek Chassis..
Works for me with a Exotek Chassis..
#128
#129
#131
I Want This Car!!!
#132
I am worried it uses the same suspension parts....
I see cyclone knuckles break every race day, many
also I see many cyclone parts where the left is 1 degree and the right is .5 degrees, not accurate
I see cyclone knuckles break every race day, many
also I see many cyclone parts where the left is 1 degree and the right is .5 degrees, not accurate
#133
No part is indestructable... If you hit things hard, graphite parts WILL fail. There are plastic more forgiving parts available...
I'm not sure what you are refering to with regards to inaccuracies? In all the HB/HPI parts I have used I've found no faults with the moulded parts.
Luke
I'm not sure what you are refering to with regards to inaccuracies? In all the HB/HPI parts I have used I've found no faults with the moulded parts.
Luke