romuald31

Hello from France,

I recently buy a CRC Genx 10, and have some problems to understand the size.

Screws in the kit:
2-56
4-40
8-32

Nuts:
2-56
4-40

What are the size tools for screws and nuts I need?

I know I need allen key 0.035 and 0.050 and I don't know other tools!!!

Thanks a lot.

Romuald

Trips

iTrader: (16)

In addition to the .035 and .050 allen wrencehs, you'll need a 1/16" allen, and a 3/32 allen. The bolt on the left rear hub takes either a 5/64 allen, OR a 2mm allen.

You'll need a 3/16 nutdriver for the 4-40 nuts. I don't recall using any 2-56 nuts in my GenX...

romuald31

Thanks a lot,

the 2-56 nut driver is for the nut that prevent the play of the ball of the front end, and also for the ballstud.

Do you know that tool?

Au revoir.

Romuald

Trips

iTrader: (16)

Sorry, I fogot about that nut in the front arm... I used a small needle-nose plier to hold that nut, but I just measured it and it is 5/32". The hex on the 2-56 ballstud is 3/16", same as the 4-40 nuts.