143LikesAwesomatix EP Touring Car (A700 Shaft Drive)
03-06-2013, 01:10 AM
#3136
Tech Rookie
I played my A700L for the first time & its handling & acceleration was superb compare to my other Japanese made touring cars; however, the rear gear diff cup on the right side popped off after a few laps of running and I've been trying to rebuild the gear diff a couple of times but the problem persisted. I am hoping someone here can help give me some hints on building the diff, so the diff cup won't pop off during running ... Thanks!
03-06-2013, 03:28 AM
#3137
Tech Rookie
Hi, i have just bought a A700L kit. Initially I will race on low grip asphalt due to low temp (now under 20°) here, any advice on inital setup? Should A700L-STD-LowRC.pdf a good setup to start with standard kit? I race stock 13.5t blinky
What are the optionals that will be worth to try on asphalt? I think grip will remain low to medium on my local truck but temps will get hotter this summer (over 50° on asphalt).
Thanks!
What are the optionals that will be worth to try on asphalt? I think grip will remain low to medium on my local truck but temps will get hotter this summer (over 50° on asphalt).
Thanks!
03-06-2013, 05:35 AM
#3138
Hi, i have just bought a A700L kit. Initially I will race on low grip asphalt due to low temp (now under 20°) here, any advice on inital setup? Should A700L-STD-LowRC.pdf a good setup to start with standard kit? I race stock 13.5t blinky
What are the optionals that will be worth to try on asphalt? I think grip will remain low to medium on my local truck but temps will get hotter this summer (over 50° on asphalt).
Thanks!
What are the optionals that will be worth to try on asphalt? I think grip will remain low to medium on my local truck but temps will get hotter this summer (over 50° on asphalt).
Thanks!
forum.awesomatix.it
ciao Alessio
03-06-2013, 06:00 AM
#3139
Tech Fanatic
I played my A700L for the first time & its handling & acceleration was superb compare to my other Japanese made touring cars; however, the rear gear diff cup on the right side popped off after a few laps of running and I've been trying to rebuild the gear diff a couple of times but the problem persisted. I am hoping someone here can help give me some hints on building the diff, so the diff cup won't pop off during running ... Thanks!
1. Check the inner OR05 O-rings. The rubber material of both O-rings should be hard. These O-rings should be noticable harder than any conventional o-rings that are using in others RC cars.
For example our OR02 O-rings for balldiff are noticable softer at about the same sizes. So the mistake in O-rings is possible.
2. Don't fill too much oil inside the geardiff ! The enough amount of air should be inside our geardiff.
03-06-2013, 06:20 AM
#3140
All - i've been trying to update my racerlog wiki on the Awesomatix series of cars. i'd encourage people to sign up for this wiki and continue other tips/tricks/etc.
http://racerlog.com/wiki/Awesomatix_A700
http://racerlog.com/wiki/Awesomatix_A700
03-06-2013, 03:38 PM
#3142
03-06-2013, 04:11 PM
#3144
03-06-2013, 05:09 PM
#3146
03-06-2013, 08:32 PM
#3148
quick update - the awesomatix usa online web store is nearly complete. the inventory is loaded, and being tested by friends/family/team drivers. hopefully the store will launch tomorrow.
03-07-2013, 04:09 PM
#3149
The web store is now live at - shop.awesomatixusa.com
and even made a prettier web page -
http://www.awesomatixusa.com
and even made a prettier web page -
http://www.awesomatixusa.com
03-07-2013, 04:44 PM
#3150
