GM Brushless
#526
the 6T delta has around 750W measured the way the lrp values are measured ... Runtime will be pretty similar
We don't use sensors as it's not necessary .... feels the same...
right now I don't know the amount of timing the Gtb has
We don't use sensors as it's not necessary .... feels the same...
right now I don't know the amount of timing the Gtb has
#527
http://demonpowerproducts.co.uk/prod...oducts_id=3949
I dont get it , why is it 750w if it says 400w ?
#528
cause one value is meassured with 6 cells and the other one with 5 cells
and, as written on the GM page the 6T has 440W at 6V (5 cells)
and, as written on the GM page the 6T has 440W at 6V (5 cells)
#529
#530
Slightly yes
#531
#532
Tech Apprentice
iTrader: (1)
....- pick mode 3 in the "controler mode" flipdown
There will be a window showing up saying: sure you want to copy the
background information?
click "yes",
then klick "no" when it asks you if you want to set the standard values
finally click ok as you know you will use the same batteries as before :-)...
There will be a window showing up saying: sure you want to copy the
background information?
click "yes",
then klick "no" when it asks you if you want to set the standard values
finally click ok as you know you will use the same batteries as before :-)...
Dear Martin,
This mode 3 loaded with mode8 values seems very good compared to mode6 and 7.
My question is since we are changing mode3 how do we load factory values on this mode? (in case its needed in future)
Should we do a factory reset thru esc button or loading a mode3 gda does the same?
I saved a mode3 gda,before swaping modes on AS-Tool.
Thanks for the tutorial.
Beware competion GM is rocking the house
#533
to undo the mode 3 changes a factory reset via button needs to be done
for modified racing just unplug the sensorwire and you are ready to go
for modified racing just unplug the sensorwire and you are ready to go
#534
Does anyone have an email address from GM/Graupner service department in Germany as I need to contact them?
Thanks Alan
Thanks Alan
#535
Tech Fanatic
iTrader: (1)
Dear alan,
you can wrote to:
[email protected]
or:
[email protected]
This folks read emails and replay asap!
Regards!
m.a.
#536
Dear alan,
you can wrote to:
[email protected]
or:
[email protected]
This folks read emails and replay asap!
Regards!
m.a.
you can wrote to:
[email protected]
or:
[email protected]
This folks read emails and replay asap!
Regards!
m.a.
Alan
#537
Tech Rookie
Alan,
Have you had an answer yet? I sent an email to check that my Genius 95 had arrived and I've heard nothing, although it's only been 3 days!
Cheers,
Ian
Have you had an answer yet? I sent an email to check that my Genius 95 had arrived and I've heard nothing, although it's only been 3 days!
Cheers,
Ian
#538
No not yet, this is very strange as the last time it sent a speedo for repair it was very quick (3 weeks post to getting it back). I'll give them a couple of more days
Alan
Alan
#539
Tech Rookie
How did they contact you last time about payment, was it email?
#540
first they sent a letter saying they had recieved it and then by email for payment and I give them my credit card number
Alan
Alan