7LikesKyosho Ultima RZ6
07-22-2016, 06:15 AM - Wikipost
|
||||||
|
||||||
|
Shameless Plug
 Kyosho RZ-6, the 2015 IFMAR World’s Top Qualifying Car Model.------------------------------------------- Find out how Jason Dias lost some weight on his RZ6. Click here. ------------------------------------------ Editable setup sheets. Sheet 1 Sheet 2 ------------------------------------------- Shock building, alternative method. Fill the oil up to the first thread. Extend the shock shaft so the eyelet bottomed out on the shock bottom. Place the piston into the shock body but let gravity pull it down into the body. Once the shock bottom reaches the shock body help align it into the body so that the treads line up. Turn the shock bottom so that it starts to thread into the body. Wait for 1 second to give the excess oil time to escape. Continue to turn, wait, turn, wait process until the shock bottom is tight. Pump the shock shaft a few times and then bottom out the eyelet to the bottom of the shock and release. Hopefully you should not have any rebound or maybe just a little bit. If you have more than you like, loosen the shock bottom, push the shock shaft down, wait for a little bit and then re-tighten the shock bottom. ----------------------------------------- Jared Tebo shock building video.
------------------------------------------- 2-15 IFMAR Worlds, A-main #1. Jared Tebo TQ using the RZ6.
------------------------------------------- 
|
||||||
10-24-2016, 12:30 AM
#79
I have to say I was pretty impressed with the buggy for the first time out with it! The steering was a bit aggressive for my taste but was easy to remedy. It jumps quite nicely and very flat! The shocks are the usual Kyosho perfection. Now if the driver could only have pulled his head outta his... Well ya know...
02-19-2017, 05:00 AM
#83
Thank you dmcmcguire.
Has anyone had issues with shearing the slipper layshaft right were the set screw holds the drive cup on I've sheared 2 of them. I'm running a 6.5. I also noticed my slipper was very aggressive so I readjusted that hopefully that's my cause of the problem. I'm running out of spare parts lol
Has anyone had issues with shearing the slipper layshaft right were the set screw holds the drive cup on I've sheared 2 of them. I'm running a 6.5. I also noticed my slipper was very aggressive so I readjusted that hopefully that's my cause of the problem. I'm running out of spare parts lol
02-23-2017, 04:51 AM
#86
Tech Master
02-24-2017, 06:17 AM
#89
