Sworkz S35-2E 1/8 eBuggy
#166
Hi! The question of steering, wedges at maximum angles of rotation...((( Who had a problem with that?
#167
Tech Champion
iTrader: (79)
2019 Sponsorship
Hey everyone it's that time of year to start thinking about renewing or become a USRC Imports driver using Sworkz vehicles. Send me a email with your race resume to [email protected] and we will make contacts as we need to. Thanks to all that has supported the team, and USRC Imports. Now let's make the 2019 team kick ass!
#168
Tech Rookie
Front lower aluminum hinge pin holders
Has anyone had issues on there build with the font lower hinge pin holders not sitting flat on gearbox mounting its like hinge pins are to long and hinge pin holder has at least a 5mm gap between hinge holder and where it butts up to gear box case, some advice would be greatly appreciated .
#169
Tech Champion
iTrader: (79)
Has anyone had issues on there build with the font lower hinge pin holders not sitting flat on gearbox mounting its like hinge pins are to long and hinge pin holder has at least a 5mm gap between hinge holder and where it butts up to gear box case, some advice would be greatly appreciated .
#170
Tech Rookie
#172
Tech Rookie
Rear hinge pins
Has anyone had a problem with the rear hinge pin block not able 2 tighten right up with 5 mms gapfrom gear box case.?
#174
Hi to all!
Can not find any thread for s35-5e....for setups, tips and tricks ???
(not for s35-3 nitro...)
Can not find any thread for s35-5e....for setups, tips and tricks ???
(not for s35-3 nitro...)
#180
Tech Adept
Just picked up a 35-3e. Any build issues/advice etc?