eciracing

I have 2 of the 1/8 Excelorin ESC's. I was updating the firmware of them last night. I did the first one with no problems. When I did the second one, it got to 26% into the transferring, and popped up an error window. After this, I tried to reconnect, and the software would not recognize that the ESC is connected. I tried restarting the software, restarting the computer, and even tried on a friends computer. Still would not recognize that the ESC is connected. I then plugged a battery into the buggy, and I had no throttle at all. Steering was fine, but nothing. Do you have any suggestions on what to do about this? Any help is greatly appreciated! Thanks so much.
Bill

Casper

iTrader: (34)

I would contact Horizon for some help

[email protected]

Updating firm wear is kind of scary. It is like updating the BIOS on a computer. If it messes up you can't boot the computer anymore.

The above e-mail address should get you going in the right direction though.