Go Back  R/C Tech Forums > General Forums > Electric Off-Road
Need serious help with Xcelorin 1/8 ESC Firmware >

Need serious help with Xcelorin 1/8 ESC Firmware

Need serious help with Xcelorin 1/8 ESC Firmware

Reply

Old 02-12-2009, 09:47 AM
  #1  
Tech Rookie
Thread Starter
 
Join Date: Aug 2008
Posts: 4
Default Need serious help with Xcelorin 1/8 ESC Firmware

I have 2 of the 1/8 Excelorin ESC's. I was updating the firmware of them last night. I did the first one with no problems. When I did the second one, it got to 26% into the transferring, and popped up an error window. After this, I tried to reconnect, and the software would not recognize that the ESC is connected. I tried restarting the software, restarting the computer, and even tried on a friends computer. Still would not recognize that the ESC is connected. I then plugged a battery into the buggy, and I had no throttle at all. Steering was fine, but nothing. Do you have any suggestions on what to do about this? Any help is greatly appreciated! Thanks so much.
Bill
eciracing is offline  
Reply With Quote
Old 02-12-2009, 12:20 PM
  #2  
Tech Prophet
iTrader: (34)
 
Casper's Avatar
 
Join Date: Aug 2004
Location: Orange, Ca
Posts: 17,865
Trader Rating: 34 (100%+)
Default

I would contact Horizon for some help

[email protected]

Updating firm wear is kind of scary. It is like updating the BIOS on a computer. If it messes up you can't boot the computer anymore.

The above e-mail address should get you going in the right direction though.
Casper is offline  
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service