custom electric nitro hawk build
im pretty happy on how this all came together
started out as a old traxxas nitro hawk chassis with a bent up rear end ,that was sitting in my parts bins cut off the bent rear end 3d printed some rustler arms and tie rods for it dug up a old original rustler trans case and installed all new style guts with vxl slipper designed a custom rear chassis stiffener/battery tray and 3d printed that and printed out a bumper i made up that i use on my rustlers and slash don't know how much it falls into vintage anymore but at its base as good as it turned out makes me wish i had another hawk chassis here https://cimg6.ibsrv.net/gimg/www.rct...3e63c1584c.jpg https://cimg8.ibsrv.net/gimg/www.rct...227da4f8f7.jpg https://cimg0.ibsrv.net/gimg/www.rct...0a140e645f.jpg https://cimg6.ibsrv.net/gimg/www.rct...ba69784b25.jpg https://cimg8.ibsrv.net/gimg/www.rct...c54b1f2822.jpg https://cimg0.ibsrv.net/gimg/www.rct...7bc4455cbb.jpg it is lol |
this thing really did turn out great
for being parts and 3d prints lol been bashing the crap out of with the only breakage being the 20t motor i was using from a old duratrax evader (installed a vintage "350 horsepower" brushed motor today for this run . such a fun truck to drive just made an order for 3 120amp brushless ecs's so im going to throw a 9.5t in this abomination soon |
All times are GMT -7. It is currently 09:29 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.