mac853

Dear Tekin:
Could you tell me if "old" Hotwire Interface could use on a Windows tablet called "MICROSOFT Surface Go 3"?https://www.microsoft.com/en-hk/surf...ot:overviewtab
Best regards

Tekin Prez

Unfortunately no. It is not windows based operating system.

mac853

Thanks for clarifying
Then about this, I guess this works, right?
https://www.asus.com/laptops/for-hom...-go-14-e1404f/

gotheframe

Here is a link to the Tekin Website for the Hotwire. Scrolling down you can compare system requirements to see if the Vivobook is compatible.

Tekin Prez

As long as it runs windows it should be fine.

InsaneRC

iTrader: (104)

OK I just got my new Tekin HotWire 3.0. But having a problem. I have connected it to my computer and it runs fine but when I try to do the Bluetooth to my Android phone (Moto G Pure/Samsung Galaxy Tab S2) it connects but I can't edit the settings. Every tab is blank (white) & I can't edit the settings in Bluetooth mode. I have updated to the newest version for the Device and ESC. But don't know why I cannot edit settings in Bluetooth mode. It connects to the ESC no problem (Bluetooth wise) but I can't edit any settings. Any help or ideas what my problem is? thanks

Cain

iTrader: (294)

Does it throw an error message after connecting or just acts like its not there?

InsaneRC

iTrader: (104)

No error messages but it does show its connected but every tab is blank so there is nothing I can click on to make adjustments

Cain

iTrader: (294)

hmm strange, usually if mine doesn't go into the right mode it goes to demo mode. You may want to give them a call direct.

Good2seaya

I have an issue with hotwire 3.0 after updating to version 2.95 on my RX8 hotwire tells me to update my app because my software is not compatible yet It will not let me update the app. Can anyone help me with this?

TonysScrews

iTrader: (13)

Is your RX8 a GEN3?

Tekin Prez

Are you using Android or IOS? V295 only works with Android App.

OffRoadJunkie

iTrader: (6)

I have a Redline G3 17.5 Spec that I would like to rebuild. Can I replace the rotor and bearings with the G4 components?

gotheframe

According to the website, the bearings are the same between the two. Looks like the rotors could be different since they dont share part numbers and there's no mention of cross compatibility.

OffRoadJunkie

iTrader: (6)

I noticed the same thing, The bearings are the same size, but the part numbers are different. I'm wondering if that is the same case with the rotors.