Reedy Li-Po 4600mAh 40c 3.7v 1cell LiPo/ Cyclone 12
03-23-2010, 08:33 AM
#1
Reedy Li-Po 4600mAh 40c 3.7v 1cell LiPo/ Cyclone 12
Reedy Li-Po 4600mAh 40c 3.7v 1cell LiPo bullet connectors - $50
perfect and run like new, charged with Hyperion and stored at 3.6v.
Cyclone 12 - $200 come lots of new spare parts.
LRP Sphere(not TC) come with LRP capacitor, heatsink, fan. only run a few times still new - $120
Team Losi Shock Matching Tool - $35
An ingenious new way for 1/5, 1/8 and 1/10 racers to virtually eliminate chassis "tweak" by precisely matching the length and dampening rate of shocks. To set length, racers attach the shocks to the matching tool and use the easy to read gauge to adjust length. To check lengths are equal all they have to do is make sure the gauge at the bottom of the tool is centered. The matching gauge swinging in the direction of the "weaker" shock during compression will indicate any difference in dampening rate.
The Shock Matching Tool is machined from anodized aluminum with a laser-etched measuring scale on the face. The pivoting gauge on the bottom of the tool is ball bearing supported for maximum precision.
Features
Hard-anodized aluminum
Ball bearing pivot gauge for maximum precision
Laser-etched measuring scale
For all racers: 1/5- to 1/10-scale
perfect and run like new, charged with Hyperion and stored at 3.6v.
Cyclone 12 - $200 come lots of new spare parts.
LRP Sphere(not TC) come with LRP capacitor, heatsink, fan. only run a few times still new - $120
Team Losi Shock Matching Tool - $35
An ingenious new way for 1/5, 1/8 and 1/10 racers to virtually eliminate chassis "tweak" by precisely matching the length and dampening rate of shocks. To set length, racers attach the shocks to the matching tool and use the easy to read gauge to adjust length. To check lengths are equal all they have to do is make sure the gauge at the bottom of the tool is centered. The matching gauge swinging in the direction of the "weaker" shock during compression will indicate any difference in dampening rate.
The Shock Matching Tool is machined from anodized aluminum with a laser-etched measuring scale on the face. The pivoting gauge on the bottom of the tool is ball bearing supported for maximum precision.
Features
Hard-anodized aluminum
Ball bearing pivot gauge for maximum precision
Laser-etched measuring scale
For all racers: 1/5- to 1/10-scale
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
