What savox servos to use in losi 8 nitro???
09-29-2011, 10:37 PM
#1
What savox servos to use in losi 8 nitro???
Need to know what servo to use for the throttle/break.
I have a new savox sc1268mg im gonna use for the steering
but for the other i'm clueless as this is my first nitro car.
Need help,thanx.
I have a new savox sc1268mg im gonna use for the steering
but for the other i'm clueless as this is my first nitro car.
Need help,thanx.
09-29-2011, 11:18 PM
#3
Just use another 1268. Get the 60 series and not the 50 series, that way you can run a lipo receiver pack direct without any regulator...ie 1268 not 1258
09-30-2011, 06:55 PM
#9
R/C Tech Elite Member
I can't help on the LiPo pack cause I only use LiFe RX packs but for the servos I can tell you that the 1268 are pretty good servos. I've ran two in my buggy and they did well all summer.
10-01-2011, 05:30 AM
#10
check reciever voltage
I run 1268mg for both steering and throt. But if your gonna run lipos check to make sure your reciever can handle the voltage.
don't know what radio your runnin, but some of the airtronics recievers are not rated for more then 6.0 volts. not sure about the other brands.
don't know what radio your runnin, but some of the airtronics recievers are not rated for more then 6.0 volts. not sure about the other brands.
10-01-2011, 06:13 AM
#12
10-01-2011, 08:57 AM
#13
Reciever voltage
Im gonna check the voltage on my reciever,thanx for that warning!you might have saved me $100.it's the airtronics fhss-2,m11 with spectrum but not sure about the actual #.
Thanx,I'm gonna go with 1268 steer
1267 throttle/brake
Thanx,I'm gonna go with 1268 steer
1267 throttle/brake
