LIPO CUTOFF FAILED!!!
#1
LIPO CUTOFF FAILED!!!
I guess my lipo cutoff was set and now when I go to balance/charge my lipo in says "low voltage" and won't let me go any further.
Anyone have a trick to bring it back to life or do I have a really cool paperweight?? Thanks in advance.
Anyone have a trick to bring it back to life or do I have a really cool paperweight?? Thanks in advance.
#2
Tech Elite
Join Date: Dec 2005
Location: 5280 Raceway. Denver's finest RC facility
Posts: 4,780
charge it on nimh for a couple of minutes, should be fine.
also make sure you are on the proper cell number on your charger, (1s, 2s)ect.
and make sure you charger is not set to lilo or life.
also make sure you are on the proper cell number on your charger, (1s, 2s)ect.
and make sure you charger is not set to lilo or life.
#3
#1 what is the voltage of your pack?
#2 what stack?
#3 check the voltage of each cell on the balance connector using a dmm.
Youll know what to do once you get all this.
#2 what stack?
#3 check the voltage of each cell on the balance connector using a dmm.
Youll know what to do once you get all this.
#4
i would not use it as paperweight...could easly take fire!
however, doble ceck the voltage with oneother charger or the small instrument made on purpose.
if it is under the treshold, seriously, i dont think u can do something which is not pretty risky!
#6
R/C Tech Elite Member
iTrader: (101)
I did this exact something a few years ago. put my charger on nimh for a few
than switched back to lipo. It was charging and looked ok but I was over charging 1 cell.
Once its discharged thats it....